ISO 3506-6-2020 Fasteners. Mechanical properties of corrosion-resistant stainless steel fasteners Part 6：General rules for the selection of stainless steels and nickel alloys for fasteners.紧固件用不锈钢和镍合金选择通则.pdf

ISO 3506-6 Fasteners - Mechanical properties of corrosion -resistant stainless steel fasteners 一 General rules for the selection of stainless steels and nickel alloys for fasteners Fixations - Caracteristiques mecaniques des fixations en acier ino秽dab/e resistant ala corrosion 一 Partie 6: Reg/es genera/es pour la selection des aciers ino秒1dab/es et des alliages de nickel pour /es fixations …，组缸‘四… ·‘ξ气 IJ ...‘E畸型~ ISO 3506-6:2020(E) COPYRIGHT PROTECTED DOCUMENT below or ISO’s member body in the country of the requester. CP 401 • Ch. d e Blandonnet 8 。ISO 2020 - All rights reserved ISO 3506-6:2 020(E) Contents F F 白 r 一 咱 S A 2 向 3 6 I E O 4 s s c 6 m a e R h 7 凰 － 8 9 6 a F M 10 A n f B 。ISO 2020 - All rights reserved ISO 3506-6:2020(E] Foreword F 。ISO 2020 - All rights r四erved ISO 3506-6:2020(E] Introduction ISO 3506-1:2009, Annexes B, C, D, E, G and H, and ISO 3506-2:2009, Annexes A, B, C, D, F and G. Fasteners - Mechanical p Part 1: Bolts, screws and studs with specified grades and property classes Part 2: Nu ts with specified grades and property classes Part 31): Set screws and similarfasteners not under tensile stress Part 41): Tapping screws Part 52): Specialfasteners (also includingfasteners from nickel alloys)for high temperature αpplications Part 6: