卸油安全操作规程.docxVIP

Safety Operating Procedures for Oil Unloading 卸油安全操作规程 prepare1. After the oil tank truck enters the warehouse, the unloading personnel shall check that the safety facilities of the oil tank truck are complete, and guide the tankDrive to the oil unloading site.2. Connect the electrostatic grounding wire and prepare the fire-fighting equipment for unloading. 一、准备 1.油罐车入库后，卸油人员应检查油罐车的安全设施是否齐全，并对油罐进行引导前往卸油现场。 2.连接静电接地线，准备好消防器材进行卸货。 2、 Unloading oil1. Check whether the unloading tank matches the type loaded on the tanker.2. Confirm the empty capacity of the unloading tank through liquid level gauge or manual measurement to prevent leakageOccurrence of oil spill accidents.3. Connect the unloading pipe as required to ensure tight connection and natural bending of the unloading pipe.4. Before unloading oil, safety precautions should be taken, and fire-fighting equipment should be prepared on site. The driver should not leaveWhen opening the oil unloading site, it is strictly prohibited to smoke and fire around, and prohibit external personnel from approaching the oil unloading site, and conduct inspectionConfirm that the oil tank metering hole is well sealed.5. The driver slowly opens the tanker unloading valve to start unloading, and the unloading personnel closely observe the unloading pipeThe operation of equipment such as pipelines and related valves should be prepared to handle possible problems at any time.6. After the oil unloading is completed, the oil unloading personnel shall confirm that the oil is completely unloaded. Close the gate valve and disassemble the unloading pipe,Close the oil discharge cap at the tank opening and retrieve the static electricity wire. 7. Guide the tank truck out of the depot. 二、卸油 1.核对卸油罐与罐车所装品种是否相符。 2.通过液位计或人工计量检测来确认卸油罐的空容量，以防止跑、冒油事故的发生。 3.按要求连接卸油管，确保卸油管结合紧密，自然弯曲。 4.卸油前应做好安全警戒，并在现场准备好消防器材。司机不应该离开卸油现场，周围严禁烟火，禁止外部人员靠近卸油现场，并进行检查确认油箱计量孔密封良好。 5.司机缓慢打开罐车卸油阀开始卸油，卸油人员密切观察卸油管线和相关阀门等设备的运行情况，以便随时处理可能出现的问题。 6.卸油完成后，卸油人员应确认卸油完成。