涵洞脚手架专项施工方案.docxVIP

0 0 涵洞脚手架施工方案 Culvert Scaffold Construction MS 1 1 目 录 Table of Contents 一、编制依据 Preparation Basis… 2 四、支架计算 Support Construction Calculation 3二、工程概况 Project Description. 2 四、支架计算 Support Construction Calculation 3 二、工程概况 Project Description. 2 五、环保及安全措施 Environmental Protection and Safety Measures… 11 一、编制依据： Preparation Basis 《建筑施工扣件式钢管脚手架安全技术规范》（JGJ130-2001） Technical Code for Safety of Steel Tubular Scaffold with Couplers (JGJ130-2001) 《混凝土结构设计规范》GB50010-2002 Code for Design of Concrete Structures GB50010-2002 《建筑结构荷载规范》(GB 50009-2001) Load Code for the Design of Building Structures (GB 50009-2001) 《钢结构设计规范》(GB 50017-2003) Code for Design of Steel Structures (GB 50017-2003) 二、工程概况 Project Description 本方案涵盖施工道路所有涵洞的现浇盖板 ,采用扣件式满堂脚手架支撑，盖板为厚度 140mm、180mm、200mm、300mm、700mm 的钢筋砼。 This scheme covers cast-in-site cover pates for all culverts for construction roads, which are supported with fastener type full hall scaffolds. The cover plate is of reinforced concrete with thickness of 140mm, 180mm, 200mm, 300mm, and 700mm respectively, 三、支架及模板施工 Support and Formwork Construction 1 满堂支架搭设 1. Full hall support erection 支架采用φ 48 脚手杆搭设，采用满堂支架，支架支撑于地板C25 钢筋砼上搭设脚手架。 The support is erected with φ 48 scaffold rods and applied with full hall supports. The support is supported on the floor’s C25 reinforced concrete for the purpose of scaffold erection. 四 支架施工计算 Support Construction Calculation 1 计算依据： Calculation basis 在计算过程中，主要结构的力学性能取如下数据： In the calculation process, mechanical properties of the main structure are taken with the following data: ． 支 架 钢 管 ： φ 4.8cm×3.5mm ， 截 面 积 A = 4.893cm2 ， 截 面 惯 性 矩 I =12.188cm ,W = 5.078cm3，回转半径: i =1.578cm 。 4 Support’s steel pipe: φ 4.8cm×3.5mm , sectional area A = 4.893cm2 , section moment of inertia I = 12.188cm , W = 5.078cm3, radius of gyration i =1.578cm . 4 方木采用红松：单重650kg / m ，顺纹压应力[σ ] =12 3 ，顺纹弯应力[ ] 12MPa w y MPa σ = ， 2 横纹弯应力[σ ] =1.8MPa ，顺纹剪应力[ y ] 1.3MPa j τ = ，弯曲剪应力[τ ] =1.9MPa ，弹性模量 E = 9× 10 MPa 。 3 ． Square timb