ASSE1010-2004水锤制动装置性能要求.docxVIP

ASSE1010-2004水锤制动装置性能要求 Performance Requirements for Water Hammer Arresters American Society of Sanitary Engineering ASSE Standard #1010-2004 ASSE Board Approved: FEBRUARY , 2004 ANSI Approved: MAY , 2004 General Information Neither this standard, nor any portion thereof, may be reproduced without the written consent of the American Society of Sanitary Engineering. No product may be said to be ASSE approved unless the manufacturer has applied to the ASSE has had his product tested according to the applicable ASSE Standards, and when the product has passed the test, displays the ASSE Seal on the product. Instructions for receiving the authorization to display the Seal are available from ASSE’s International Office. Organizations wishing to adopt or list any ASSE Standard should print the ASSE Standard number on the cover page first and in equal or larger type to that of the adopting or listing organization. American Society of Sanitary Engineering Westlake, Ohio Copyright ? 2004, 1996, 1982, 1967 All rights reserved. Foreword The foreword is not a part of this standard; however it is offered to provide background infor-mation. Water Hammer shock has long been known to be a destructive force in plumbing water sup-ply systems. Water hammer is that condition which defines the destructive forces, pounding noises and vibration caused by the immediate cessation of water flowing in a pipeline. After years of study on this issue, the Plumbing and Drainage Institute published their findings in 1965 in a publication entitled Standard PDI-WH201 “Water Hammer Arresters.” Water hammer forces can be controlled with a reduction of the intensity of the shock wave. Although some codes permit the use of an air chamber to temper the shock wave, the engi-neering community generally agrees that the installation of an Engineered Water Hammer Arrester to reduce the shock wave intensity. Air chambers are required to be oversized to be effective. Because they are subject to loss of the air c