(7415)--浅析改善高透离线可钢Low_E玻璃耐加工性的方法.pdfVIP

玻璃深加工 浅析改善高透离线可钢Low-E玻璃耐加工性的方法 摘　要　通过对真空磁控溅射方法生产 的高透可钢Low-E镀膜采用氧化镍铬作为银层保护层和使用氧化锆作为最外层保护 层 的方法对膜层进行改善 。对制备试样分别进行不 同浓度 的盐酸及氢氧化钠溶液浸泡 ，对膜面作不 同莫 氏硬度及不 同程度 的研磨测试 ，而后对可见光透过率和膜面形貌进行测量对 比。实验表明 ：通过使用氧化镍铬作为银层保护层及氧化锆作为 最外层保护层可以明显改善高透可钢Low-E抗划伤性 ，同时氧化锆可提高膜层 的耐腐蚀性能而氧化镍铬 的使用会降低耐腐 蚀性。本实验为加工异地可钢产品尤其是高透双银产品膜层设计提供了一定的理论及实践指导。 关键词　高透可钢Low-E玻璃；耐加工；氧化镍铬；氧化锆 中图分类号：TQ171　文献标识码：A　文章编号：1003－1987（2020）04－0041－06 Discussion on the Method to Improve the Workability of High Transmission Tempered ZHU Honggang （Tianj in Northern glass industry t echnology C o., Ltd., Tianj in 301800, China ） Abstract: The high transmission tempered Low-E film produced by vacuum magnetron sputtering is improved by using nickel-chromium oxide as the protective layer of silver film and zirconium oxide as the outmost protective layer. The prepared sample is immersed in hydrochloric acid and sodium hydroxide at different concentrations respectively, and the film surface is ground with different Mohs hardness, then the visible transmittance and film surface morphology are tested and compared. The results show that the scratch resistance of the high transmission tempered Low-E is improved significantly by using the nickel- chromium oxide as the protective layer of silver film and zirconium oxide as the outmost protective layer. At the same time, zirconium oxide can improve the corrosive resistance of the film and the use of nickel- chromium oxide will reduce the corrosive resistance. This experiment provides some theoretical and practical guidance for the design of film layers of tempered glass products, especially the design of high transmission double-silver film layers, which is processed at long-distance places. Key Words: high transmission tempered Low-E glass,