路由器外壳注塑模具设计说明书(1).docxVIP

PAGE IV PAGE IV 摘 要 本次毕业设计的题目是塑料路由器外壳的注塑模具设计，通过查阅资料，确定了本次设计的流程和需要完成的操作。 1.对产品的分析，（具体包含产品的结构特点和成型特点，对产品进行三维建模，选取适合产品的注塑材料） 2.注射设备的选取，(根据完成产品需要的塑料凝料的总量和模具大致的高度来进行注射机的初步选取) 3.模具整体结构的设计，（分型面的选取，型腔的排布，成型零部件的设计与计算，模架的选取，主流道，分流道，浇口的设计，导向机构，推出机构，排气系统和冷却系统的设计） 4.装配图的绘制，（对完成整个注射流程的各个系统进行整合之后，绘制模具整体装配图） 5.注射机的校核，（根据装配图来对初选的注射机进行各个方面的校核，包含模具高度，总的注射量，模具的锁模力和开模时的高度等方面的校核） 关键字：注塑模具，侧浇口，CAD。 Abstract The title of this graduation project is the injection mold design of keyboard shell. By consulting the data, the design process and the operation to be completed are determined. 1. Analysis of the product (including the structural characteristics and molding characteristics of the product, 3D modeling of the product, selection of injection materials suitable for the product) 2. Selection of injection equipment (the initial selection of injection machine is based on the approximate height of plastic condensate and mold required to complete the product) 3. Design of the overall structure of the mold (selection of parting surface, layout of cavity, design and calculation of forming parts, selection of mold base, design of main flow channel, shunt channel, gate, guide mechanism, push out mechanism, exhaust system and cooling system) 4. Drawing of assembly drawing (drawing the overall assembly drawing of the mold after the integration of all systems of the whole injection process) 5.Verification of injection machine (check all aspects of the preliminarily selected injection machine according to the assembly drawing, including the verification of mold height, total injection volume, mold locking force and mold opening height, etc.) Keywords: injection mold， side gate， CAD. 目 录 TOC \o 1-3 \h \u 1 绪论 1 2 塑件分析 3 2.1 塑件工艺性分析 3 2.1.1 尺寸精度的分析 3 2.1.2 脱模斜度的分析 3 2.1.3 表面粗糙度的分析 3 2.2 塑件材料分析 3 3注射机的选择 5 3.1注射机概况 5 3.2对于注塑机的选择 5 4模具结构设计 7 4.1 分型面的选取 7 4.2 型腔数目的确定 7 4.3 成型零件的设计和尺寸计算 8 4.3.1 型腔的设计 8 4.3.2 型芯的设计 8 4.3.3成型零件的尺寸计算 9 4.4 模架的选取 12