RockwellAutomation罗克韦尔800T selector switch locking cover installation instruction 用户手册说明书.pdf

MOUNTING INSTRUCTIONS Bulletin 800T Selector Switch Locking Cover This locking cover is for use wiih Allen-Bradiey Builetin 800T Standard Knob Selector Switches onily, and is intend- ed to guard against unauthorized operation cf 由 e device. Builetin 800T legend plate or trim washer must be Used with the locking cover. Use legend plate with notch instead of tang. (800T-X500 and X600 Series) CAUTION: Depending on mounting dimensions to ad- jacent unitsand thetypes of units invalved , interference may occur between the iocking cover and/or padtlock and parts of, or operation of, adjacent units. Be sure tp eheek for possible interference before installing device， Panel [178”{3.2) Thicknesss iiiustrated] Legand Plate or Trim Washer 人 上 Mounting Legsrnd Plate Trimm Washer Bracket | La 于 晶 ide Thrust Washer 上 加 Locking 名 鱼 Coever 唱 屯 ctagonal Mounting Ring Ring Gasket (See Table) Thrust Washer [{Tang Engages Panei} To mount sejector switch unit with locking cover, place correct number of ring gaskets on mounting bushing as indicated in tabie, assemble bushing in hole of panel and paosition legend plate and thrust washer. Mount locking COver assembly with hinge at top, unlatch angd iift cover， position mounting ring over end of bushing and thread mounting ring onto bushing using thumb and finger， Tighten mounting ring securely. The cctagon mounting ring should be in line with the cover cctagon to provide for free cover movement. NOTE: Trim washer (supp