使用radioss hs 1060进行冲击模拟尺寸优化研究.pdfVIP

Size Optimization Study on an Impact Simulation Using RADIOSS - HS-1060 This tutorial demonstrates how to perform a size optimization on a finite element model defined for RADIOSS. The RADIOSS model shown in figure 1 is defined in Block format and needs to be run using the RADIOSS Star nd Engine. The sample base input files can be found in install_directory/tutorials/hst/Radioss/. Copy the files in this directory to your working directory. The directory ludes the following files: boxbeam1_0000.rad Original RADIOSS Starter input file in Block Format boxbeam1_0001.rad Original RADIOSS Engine input file in Block Format boxbeam1.tpl Base input tem te. The objective is to minimize the mass of the beam under the followin o constraints: the internal energy must be more than 450, and the resulting reaction must be less than 75. The design variables are the thicknesses of the four components defined in the input deck boxbeam1._0000.rad via the /PROP/S entries. They are combined into two design variables. The thickness should b ween 0.5 and 2.0; the initial thickness is 1.0. The optimization type is size. Figure 1. Boxbeam model, undeformed. Figure 2. Boxbeam model, deformed, t = 2.001. Step 1: Create the base input tem te in HyperStudy 1. Start HyperStudy. 2. Go to the Tools pull-down and click Create Tem te…. 3. In the open window, go to File and Import… the file boxbeam1_0000.rad. 4. Under Edit, use Find… to search for /PROP/S . Below, you will find the label Thick that marks the s thickness for each component in the line below. The thickness is defined by a field with 20 characters. We need to re ce the numbers with formatted Templex statements to mark a design variable. 5. From the Edit p