基于dsPIC30F的船舶机舱模拟量采集终端的研究与设计的中期报告.docxVIP

基于dsPIC30F的船舶机舱模拟量采集终端的研究与设计的中期报告 摘要： 以船舶机舱模拟量采集终端为研究对象，结合dsPIC30F系列微控制器的特点，进行综合设计与研究。本项目以实现机舱模拟量采集为主要目标，通过调查分析船舶机舱信号的特点，确定了采集的参数与要求，并且设计出了相应的硬件电路和嵌入式软件。在设计中采用了AD汇流排和四路模拟输入通道来进行信号采集，同时利用EEPROM存储参数和实现通信。在软件方面，采用了C语言进行编程，实现了信号采集、数据存储、通信传输等功能。中期报告主要对硬件电路和软件实现进行了详细的介绍和分析，并进行了实验验证。实验结果表明，本项目能够稳定、准确地采集船舶机舱模拟量信号，并可以进行数据存储和通信传输。 关键词：dsPIC30F；船舶机舱模拟量采集终端；信号采集；数据存储；通信传输 Abstract: This project aims to design and research a ships engine room analog signal acquisition terminal based on the characteristics of dsPIC30F series microcontrollers. The main goal of this project is to achieve the acquisition of analog signals in the engine room. Based on the investigation and analysis of the characteristics of the signals in the engine room, the parameters and requirements for acquisition are determined, and the corresponding hardware circuit and embedded software are designed. AD bus and four-channel analog input channels are used to collect signals, and EEPROM is used to store parameters and implement communication. In terms of software, C language is used for programming to realize signal acquisition, data storage, communication transmission and other functions. The mid-term report mainly introduces and analyzes the hardware circuit and software implementation in detail, and conducts experimental verification. The experimental results show that this project can stably and accurately collect analog signals in the engine room, and can perform data storage and communication transmission. Keywords: dsPIC30F; ships engine room analog signal acquisition terminal; signal acquisition; data storage; communication transmission