Danfoss丹佛斯IKORE B and R11 Installation Guide 安装指南.pdf

ENGINEERING TOMORROW Remote Control IKOREB and RT1 1 The status LED will pulse green until the transmitter is Danfoss does not take responsibility for incorrect installation cr linked with the receiver. The LED will turn into a continuous any frequency interference. green when the receiver confirms the link. Chance of unintended machine movement on start up. Ensure the machine is stopped forthe entire duration ofthe assembly process. Keep the work area free and wear protective clothing-. To maximize Product life, it is essential to use Danfoss original BT11K batteries. The system is now fully operational. 1. Connect the power supply and the outputs according to the connection block diagram provided with the systemn. 3. Push and pull outthe STOP button. The status LED will pulse blue until the stand by mode is reach, then it willturn into a continuous blue. 4, Press the start button- 8 Danfoss | September 2021 AN293564394817en-000201 | 1 ENGINEERING TOMORROW Description Hoist Selection During the hoist selection, activating maneuvers is not allowed.