WB900-19960701-附录E 外梅花尺寸-中文.pdfVIP

LobedExternalDriveSystemforThreadedFasteners

WB900APPENDIXE

螺纹紧固件外拧入凹槽法

共6页第1页

Date:1996-10-01

1.SCOPE.ThisAppendixcoversthedimensionalandgaugingrequirementsfora6lobedexternaldrive

systemusedonthreadedstudsandheadlessscrews.

1.范围。本附件包含了使用螺柱和无头螺栓内拧入方法的内花形螺栓测量要求和尺寸要求。

2.DIMENSIONS.尺寸

ThedimensionsofstudsandheadlessscrewsarereferencedinFigureE1andTableE1butshallmeetthe

GaugingrequirementsspecifiedinClause3.

螺柱和无头螺栓的尺寸应参见图E1和表E1，但也应满足第3条的测量要求。

3.GAUGINGOFHEADLESSSCREWDRIVEFEATURES.无头螺栓拧入端测量。

3.1Thewrenchingheight(K)shallbecheckedusingthegaugespecifiedinFigureE2andTableE2.

Partsshallbeconsideredacceptableifthetopsurfaceofthelobedheadliesflushwithorextends

BeyondthetopsurfaceofthegaugeasshowninFigureE2-A.

3.1扳拧高度(K)应使用图E2和表E2指定的环规来检查,测量,如图E2-A所示,如果零件头顶部凹槽有飞

边或量规顶部表面以外有,是可以接受的.

3.2Theoutsidediameter(A)ofthedrivefeatureshallbecheckedusingthegogaugespecifiedin

FigureE2andTableE2.Partsareconsideredacceptableifallofthelobeddrivesystementersthe

GaugeasshowninFigureE2-B.

3.2拧入端外径(A)可以用图E2和表E2指定的通规来测量.如果所有凹穴拧入方法能拧入图E2-B中的

环规,零件也可以接受.

3.3ThefallawayoflobeddrivefeaturesshallbecheckedusingthegaugespecifiedinFigureE2and

TableE2.Partsareconsideredacceptableiftheuppersurfaceofthedrivefeaturedoesnot

ProtrudeabovethetopsurfaceofthegaugeasshowninFigureE2-C.

3.3通过图E2和表E2指定的量规来测量凹穴拧入度的倾斜度,如果零件拧入端的上表面不超过图E2-C

中量规的顶部表面,零件可以接受.

4.FORMANDPOSITION.Theconcentricityoftheoutsidediameterofthelobestotheinnerdiameterof

ThelobevalleysshallbecheckedwiththegaugeshowninFigureE3andTableE3.Partsshallbe

Consideredacceptableiftheentirelobeddri