垃圾焚烧发电厂自动控制系统的设计与实现.pdfVIP

  • 0
  • 0
  • 约1.6万字
  • 约 5页
  • 2025-12-30 发布于山东
  • 举报

垃圾焚烧发电厂自动控制系统的设计与实现.pdf

第41卷第9期自动化仪表Vol.41No.9

2020年9月PROCESSAUTOMATIONINSTRUMENTATIONSep.2020

垃圾焚烧发电厂自动控制系统的设计与实现

黄达

(国核自仪系统工程有限公司,上海200241)

摘要:以某垃圾焚烧发电厂为研究对象,分析垃圾处理的工艺流程,构建垃圾焚烧发电厂自动控制系统,从系统设计、硬件配置、

软件组态和现场总线通信等方面,探讨了NuCON-P系统在垃圾焚烧发电厂中的应用。垃圾焚烧发电厂自动控制系统以NuCON-P分

散控制系统(DCS)作为控制平台,采用CANBUS与Ethernet结合的两层网络架构,并集成有一定数量的可编程逻辑控制器(PLC)和现

场总线仪表。在分析用户需求的基础上.编制了有效、实用的控制程序,开发了图形化的人机界面,并实现了与PLC和现场总线仪表

的通信,从而构成了一套控制功能强、可靠性髙、开放性好的自动控制系统。该研究对垃圾焚烧发电厂自动控制系统的设计与实施有

一定参考意义。

关键词:自动控制;分散控制系统;计算机控制;垃圾焚烧发电;自动燃烧控制;现场总线;垃圾处理;环境保护

中图分类号:TH86文献标志码:ADOI:10.16086/j.cnki.issn1000-0380.2019080028

DesignandImplementationofAutomaticControlSystem

forWasteIncinerationPowerPlant

HUANGDa

(StatNuclearPowerAutomationSystemEnginringCo.,Ltd.,Shanghai200241,China)

Abstract:Takingawastincinerationpowerplantasthresearchobject,thprocessflowofwastdisposalwasanalyzed,andth

automaticcontrolsystemofwastincinerationpowerplantwasconstructed.ThapplicationofNuCON-Psysteminwast

incinerationpowerplantwasdiscussedfromthaspectsofsystemdesign,hardwarconfiguration,softwarconfigurationand

fieldbuscommunication.NuCON-Pdistributedcontrolsystem(DCS)wasselectedasthcontrolplatformofthautomaticcontrol

systemofwastincinerationpowerplant,forwhichatwo・layernetworkarchitecturcombiningCANBUSandEthernetwas

adopted,andacertainnumberofprogrammerlogiccontroller(PLC)andfieldbusinstrumentswerintegrated.Onthbasisof

analyzingthusersnds,aneffectivandpracticalcontrolprogramandagraphicalh

文档评论(0)

1亿VIP精品文档

相关文档