HP_Superdome_培训.ppt

See warning. Last known - last known good profile. Genesis - start new profile from scratch, usually uses Cell 0. After you finish the UNIX module, this will be a little more clear To put in all your IP addresses. After it resets the system it blocks boot (BIB). Doesnt block boot. * HP template * * * Complex Configuration – cc Command Genesis profile defines cell for partition 0. Cell chosen should have bootable device attached. This command allows you to change the complex profile. WARNING: You must either shut down the OSs for reconfiguration or execute the RR (reset for reconfiguration) command for all partitions before executing this command. G - Build genesis complex profile L - Restore last complex profile Select profile to build or restore: * * LAN Configuration – lc Command This command modifies the LAN parameters. Current configuration of GSP customer LAN interface MAC address : 00:10:83:fd:07:68 IP address : 15.32.65.48 0x0f204130 Name : mvsd1-g Subnet mask : 255.255.248.0 0xfffff800 Gateway : 15.32.64.1 0x0f204001 Status : UP and RUNNING Do you want to modify the configuration for the customer LAN? (Y/[N]) * * Reset Partition for Re-configuration – rr Command This command resets for reconfiguration the selected partition. WARNING: Execution of this command irrecoverably halts all system processing and I/O activity and restarts the selected partition in a way that it can be reconfigured. # Name --- ---- 0) mvsd1p0 1) mvsd1p1 Select a partition number: * * Reset Partition for Re-configuration – rs Command This command resets the selected partition. WARNING: Execution of this command irrecoverably halts all system processing and I/O activity and restarts the selected partition. # Name --- ---- 0) mvsd1p0 1) mvsd1p1 Select a partition number: