有柄盖注塑模具设计毕业设计说明书.docVIP

` PAGE 36 Abstract This design needing the thickness of plastic uniform, the surface should be smooth .Considering the size of product is large, so the design uses one-mode and one-cavity form in this case. The design also use half-structure to forming the handle of product after analyzing the structure of the product. In order to ensuring the surface smooth, the edge without distortion, we use pneumatic ejection structure. This structure also simplifies the mold structure, economical and practical. Meanwhile, we measured the connection between product quality and the cost. Making the mold of simple structure、low processing costs of production、easy processing and usability as much as possible. Key words Mug; Injection Mould; Half-structure; Pneumatic ejection structure 目 录 TOC \o 1-4 \h \u  HYPERLINK \l _Toc259900794 摘要、关键词  PAGEREF _Toc259900794 \h I  HYPERLINK \l _Toc259900796 Abstract、Key words  PAGEREF _Toc259900796 \h II  HYPERLINK \l _Toc259900798 目录  PAGEREF _Toc259900798 \h III  HYPERLINK \l _Toc259900799 1.引言  PAGEREF _Toc259900799 \h 1  HYPERLINK \l _Toc259900800 2.塑料工艺分析与模具方案确定  PAGEREF _Toc259900800 \h 2  HYPERLINK \l _Toc259900801 2.1 制件的分析  PAGEREF _Toc259900801 \h 2  HYPERLINK \l _Toc259900802 2.2 模具方案的初步确定  PAGEREF _Toc259900802 \h 3  HYPERLINK \l _Toc259900803 2.3总装图  PAGEREF _Toc259900803 \h 3  HYPERLINK \l _Toc259900804 3. 塑料的成型特性及工艺参数  PAGEREF _Toc259900804 \h 4  HYPERLINK \l _Toc259900805 4. 注塑设备的选择  PAGEREF _Toc259900805 \h 4  HYPERLINK \l _Toc259900806 4.1 计算塑件的体积和重量  PAGEREF _Toc259900806 \h 4  HYPERLINK \l _Toc259900807 4.2 选择设备型号、规格、确定型腔数  PAGEREF _Toc259900807 \h 4  HYPERLINK \l _Toc259900808 5. 浇注系统  PAGEREF _Toc259900808 \h 5  HYPERLINK \l _Toc259900809 5.1 确定成型位置  PAGEREF _Toc259900809 \h 5  HYPERLINK \l _Toc259900810 5.2 分型面的选择  PAGEREF _Toc259900810 \h 5  HYPERLINK \l _Toc259900811 5.3 浇口套的选用  PAGEREF _Toc259900811 \h 6  HYPERLI