全优润滑管理(2011版).ppt

菲尔德（北京）净油设备有限公司 www.F 检测数据分析 液压油分析 Viscosity (cSt at 40°C) Exceeds limit +/- 10% Viscosity increase is more common than decrease. It should be noted and checked at more frequent intervals. Check that the correct grade of oil is used for top-up. Water (%) Satisfactory 0.05% - 0.15% Upper limit should be checked against manufacturers’ data. Some oils cannot tolerate water - BEWARE. Data not applicable to water or phosphate ester-based hydraulic fluids. Borderline 0.15% - 0.2% Exceeds limit 0.20% TAN Exceeds limit +/- 0.6 TAN should always be monitored by trend as the TAN of some oils can fall from new then rise again as the oil ages. Particulates Refer to manufacturers data Hydraulic systems can be extremely sensitive to wear from particulate contamination and great care should be taken to ensure all filters are in good condition and no dirt enters via top-up oil or tank vents. Failure due to acidic-erosion 菲尔德（北京）净油设备有限公司 www.F 检测数据分析 汽轮机油分析 Viscosity (cSt at 40°C) Exceeds limit +/- 10% nom Viscosity increase is more common than decrease. It should be noted and checked at more frequent intervals. Check that the correct grade of oil is used for top-up. Water (%) Satisfactory 0.05% - 0.15% Upper limit should be checked against manufacturers’ data. Some oils, especially synthetic oils, cannot tolerate water - BEWARE. Water contamination may lead to hydrolysis of synthetic oils and rapid TAN increase. Exceed 0.20% TAN Exceed Change +/- 0.4 from nominal TAN should always be monitored by trend as the TAN of some oils can fall from new then rise again as the oil ages. Lubricant varnishing 菲尔德（北京）净油设备有限公司 www.F 检测数据分析 压缩机润滑油分析 Viscosity (cSt at 40°C) Satisfactory +/- 15% A viscosity increase is more common than decrease. It should be noted and checked at more frequent intervals. Check that the correct grade of oil is used for top-up. Borderline nom 15-20% Water (%) Satisfactory 0.05% - 0.10% Water can enter the oil via the compressor cylinders; always check that int