金刚石精珩铸铁内孔珩磨工具分析研究论文.doc

PAGE 毕业论文 题 目: 金刚石精珩铸铁内孔珩磨工具研究 摘 要 金刚石珩磨所加工的铸铁材质具有很高的硬脆性,根据具体的珩磨工艺要求以及珩磨设备性能等情况,针对其磨削机理和工艺特点,在确定合适的金刚石磨料的情况下,合理选择结合剂类型,采用合适的结合剂成分,通过测定抗折强度和硬度，对试验分析研究,优化设计出最佳的结合剂配方。根据被加工对象材质特性及珩磨工艺要求,为了保证金刚石珩磨油石具有较高的磨削效率和较长的使用寿命,就必须合理选择结合剂类型和成分及配比,使得金刚石珩磨油石在磨削时结合剂的性能与金刚石磨料以及珩磨工艺相适应。为此,我们进行了大量试验和分析研究。第一轮进行正交实验设计，根据实验结果正交分析出较优配方，最后选定Cu78Sn20Fe6Co6和Cu80Sn10Fe8Co2为最佳配方，并可在工厂进行试用。 关键词： 珩磨机理 内孔加工 正交实验 抗折强度 硬度 Title Research In diamond fine top cast iron hole honing tool Abstract Diamond processing by honing the cast iron is very hard and brittle material, According to the honing of specific requirements and honing equipment performance, for itsgrinding mechanism and process characteristics, In determining the appropriate diamond abrasive circumstances, a reasonable choice of agent types, using the right combination of elements, Determination by bending strength and hardness, the test analysis and study, designed to optimize the combination of the best formula. According to the processing of material objects and honing technical requirements, To ensure that diamond honing Whetstone has a high grinding efficiency and longer service life, we must combine a reasonable choice of type and composition and ratio, makes diamond grinding, honing Whetstone in combination with the performance of diamond abrasive and honing process Line. To this end, we conducted a lot of testing and analysis. The first round of orthogonal experimental design，According to results of the orthogonal optimum formula, the final selection Cu78Sn20Fe6Co6 and Cu80Sn10Fe8Co2 as the best formula, and in the plant for trial. Keywords Honing Mechanism Hole in the processing Orthogonal test Bending strength Hardness 目 录 TOC \o 1-2 \h \z \u HYPERLINK \l _Toc486134508 1 引言 PAGEREF _Toc486134508 \h 1 HYPERLINK \l _Toc486134509 1．1 珩磨内孔加工机理 PAGEREF _Toc