(毕业论文)甲醇合成工段设计.docVIP

蝿衿芈蒆羁肅芄蒅蚁羈膀蒄螃膃肆蒃袅羆莅蒂薅膂芁蒁蚇羄膇薀蝿膀肃薀袂羃莁 （ 摘要 目前生产甲醇的主要原料是煤和天然气，甲醇的生产工艺过程分为合成气（氢和一氧化碳)的制造、甲醇的合成和精制3部分。用煤和焦炭制甲醇的工艺路线包括燃料的气化、气体的脱硫、变换、脱碳及甲醇合成与精制。本文设计了甲醇的合成和精馏工艺，设计中采用低压法中的I.C.I法合成甲醇，采用双效法三塔粗甲醇精馏工艺来对粗甲醇进行精馏。工艺流程是指采用低温、低压和高活性铜基催化剂，在5MPa左右压力下，由合成气合成甲醇的工艺流程本设计采用ICI法合成甲醇，催化剂为铜基催化剂，其活性组分是Cu和ZnO，该催化剂的活性高。合成反应的温度较低，在（230-270℃），操作压力较低（5-10Ma）广泛用于甲醇合成。本精馏工艺采用双效法三塔粗甲醇精馏工艺与双塔精馏相比三塔精馏可以提高甲醇的质量和收率，并且可以降低蒸汽消耗。关键词：I.C.I低压法双效法三塔粗甲醇精馏 Abstract Currently the main raw material production of methanol was from coal and natural gas, methanol production process was distinguished into three parts， such as the production of synthesis gas (hydrogen and carbon monoxide), synthesis and refining of methanol. in the manufacture of methanol synthesis and coal and coke manufacturing process route were included methanol fuel gasification, gas desulfurization, transformation, decarburization and methanol synthesis and purification. This design for methanol synthesis and distillation process, the design of the ICI low pressure methanol synthesis, double-follow three towers to crude methanol distillation of crude methanol distillation. Low-pressure methanol synthesis process was the use of low-temperature, low pressure and high activity copper-based catalyst, in 5MPa about pressure, synthesis gas from the methanol synthesis process. This design was used ICI methanol synthesis catalyst for the copper-based catalyst; the active component is Cu and ZnO, the catalyst of high activity. Reaction temperature was lower, at (230~270℃), low operating pressure (5-10Mpa), which widely used in methanol synthesis. The design of double distillation process of crude methanol distillation process to follow three towers, distillation towers, which compared with three towers distillation of methanol can improve the quality and yield, and reduce steam consumption. The design calculations for methanol synthesis section in the production process and distillation steps, was the material balance and heat balance, and methanol a