销轴受力性能分析与设计.pdfVIP

第 39 卷 第 6 期 建 　筑 　结 　构 2009 年 6 月 销轴受力性能分析与设计 1 2 2 王 　帅 , 赵宪忠 , 陈以一 ( 1 华东建筑设计研究院 ,上海 200002 ; 2 同济大学土木工程学院 ,上海 200092) [摘要] 　针对销轴节点的受力和构造特点 ,利用有限元方法对销轴直径、上下耳板宽度等进行了参数分析 ,结果发 现销轴上有两处受力较大 ,分别为跨中处和下耳板对销轴的挤压处。在假定下耳板对销轴的压力在有效宽度内均 匀分布的基础上 ,推导出销轴承载力 F2 的计算公式;在假定上耳板对销轴的压力呈二次曲线分布的基础上 ,推导 出销轴承载力 F1 的计算公式。销轴的实际承载力取上述算式结果的较小者。将计算公式的计算结果与有限元模 拟的结果相比 ,两者吻合良好 ,说明相关公式可供设计采用。 [ 关键词] 　销轴 ; 铰节点 ; 有限元 ; 公式推导 Mechanical behavior and design equation for pins connected plates 1 2 2 Wang Shuai , Zhao Xianzhong , Chen Yiyi ( ) 1 East China Architectural Design Research Institute Co. , Ltd. , Shanghai 200002 , China ; 2 Tongji University , Shanghai 200092 , China 库 Abstract :Parametric analyses on diameter of the pin and the thickness of the connected plates of the pin are performed using FEA. The characteristic of load transfer and mechanism of the pin are obtained : the control point of the pin failure lies in the middle point ( ) 例 ( ) of the pin shaft point 1 and the point on the pin shaft where the bottom connected plate crushes point 2 . The design equations for ultimate capacity of pins at point 1 and 2 are derived with assumed stress distribution modes along point 1 and 2 , and the ultimate capacity of pins is taken as the smaller of that at point 1 and 2. The results calculated from the design equations agree well