Moore-Penrose逆的索网天线预拉力设计方法.pdfVIP

基于 Moore-Penrose 逆的索网天线预拉力设计方法* 杨东武 仇原鹰 保 宏 (西安电子科技大学机电工程学院 西安 710071) 摘要：为保证星载索网天线反射型面具有一定的刚度和热稳定性，展开态的索网结构须具有一定的预应力。结合天线 索网结构的组成特点，将索网结构的预拉力设计过程分为三个阶段，即先优化设计前索网面索段的预拉力，然后计算 纵向拉索的索段预拉力，最后优化设计后索网面的索段预拉力。在前、后两次网面索段预拉力的优化设计中，网面索 段预拉力的均匀化程度以网面中各索段拉力与网面索段的拉力均值之间的差值平方和大小来衡量；认为差值平方和越 小，网面索段拉力越均匀。以索网结点在理想位置力平衡所需满足的方程为主要约束条件，建立索网预拉力优化设计 的数学模型。结合线性相容方程组极小范数解的概念，通过模型等效转换讨论其有效求解方法。算例结果表明，以网 面索段拉力与其均值的差方和最小为目标来优化设计索网预拉力的方法简便、有效。 关键词：反射面天线 索网反射面 预拉力 极小范数 中图分类号：V443 Least-Norm Method for Pretension Optimization of Mesh Reflector YANG Dongwu QIU Yuanying BAO Hong (School of Electromechanical Engineering, Xidian University, Xi’an 710071) Abstract ：To ensure space-borne mesh antenna reflector on state has a stable surface shape under vibration and thermal environments, the mesh structure shall be pre-stressed. Based on the component characteristics of mesh antenna structure, the cable pretension design process is divided into three stages, i.e., the tension optimum design of cables in the front net, the calculation of tensions in the tension ties, and the tension optimum design of cables in the rear net. While optimization design on tensions is done for the cables in the front net or in the rear net, the squared deviation of each tension from the mean is used to measure the uniformity of the tensions, and the smaller is the squared deviation, the more evenly the net cable tensions are thought to be. With the force balance equations of the net structure as the main constraints, tension optimum design models are established. Based on the concept of the least-norm solution of consistent linear equation system, method for solving the optimization models is developed. Simulation results show the effectiveness of the measure criterion on the un