离子渗氮对马氏体时效钢微观结构和性能的影响英文翻译.docVIP

英文翻译原文 EFFECT of ION NITRIDING ON the MICROSTRUCTURE AND PROPERTIES of MARAGING STEEL (250 GRADE) Kishora ShettyS. Kumarb,P. Raghothama Rao;Regional Centre for Military Airworthiness (Foundry and Forge), CEMILAC, DRDO, Bangalore-560 037, India Department of Materials Engineering, Indian Institute of Science, Bangalore-560 012, India Received 25 June 2008. Accepted 28 November 2008. Available online 10 December 2008 Abstract In the present investigation, ion nitriding of Maraging steel (250 grade) has been carried out at three different temperatures i.e., at 435℃, 450℃ and 465℃ for 10?h duration in order to achieve good wear resistance along with high strength required for the slat track component of aircraft. The microstructure of the base material and the nitrided layer was examined by optical and scanning electron microscope, and various phases present were determined by X-ray diffraction. Various properties, such as, hardness, case depth, tensile, impact, fatigue properties and corrosion resistance were investigated for both un-nitrided and ion-nitrided materials. It is observed that the microstructure of the core material remains unaltered and Fe4N is formed in the hardened surface layer after ion nitriding at all the three temperatures employed. Surface hardness increases substantially after ion nitriding. Surface hardness remains almost the same but case depth increases with the increase in ion nitriding temperature due to greater diffusivity at higher temperatures. Tensile strength, fatigue strength and corrosion resistance are improved but ductility and energy absorbed in impact test decrease on ion nitriding. These results are explained on the basis of microstructural observations. The properties obtained after ion nitriding at 450?°C for 10?h are found to be optimum when compared to the other two ion nitriding temperatures. Keywords：Ionnitriding;Maragingsteel;Microstructure;Casedepth; Tensile properties;Fatigue properties 1. Introduction Surface engineer