模具制造专业毕业论文--手机充电器外壳塑料模具设计.docVIP

摘 要 这套设计是精心从图书馆查资料、和指导老师讨论、分析和整理成文，做出了这个手机充电器外壳的设计。该课题从产品的材料选取，结构工艺性，具体模具结构出发，采用Pro/ENGINEER软件绘制零件的3D造型、成型零件中分型面确定与开模、浇注系统与冷却系统设计，顶出系统和模架的选择与参数的设置，并且运用了Auto CAD2007绘制了2D图纸。另外该套模具巧妙的设计了拉料杆，保证了凝料在第一次分型时留在凹模板一侧，顶杆推动推杆固定板时凝料自动脱落，实现了从射到塑件被顶出的全自动化，提高了生产效率。该副模具的开合模动作完全符合设计要求，适于大批量生产Abstract This nested design is carefully looks up the material from the library, and instructs teacher to discuss, to analyze and reorganizes the article, has made this handset battery charger outer covering design.This topic from the product material selection, the structure technology capability, the concrete mold structure embarks, uses Pro/ENGINEER the software plan components in the 3D modelling, the formation components is divided the profile to determine with operates the mold, the casting system and the cooling system design, goes against the system and the pould frame choice and the parameter establishment, and utilized Auto CAD2007 to draw up the 2D blueprint.Moreover this set of mold ingenious design has pulled the material pole, had guaranteed congeals the material when the first minute kept concave template one side, the roof bar impelled when the throwout lever dead plate congeals the material to fall off automatically, realizes from has injected to models the entire automation which went against, enhanced the production efficiency.Was advantageous in enhances the mold the production efficiency and saved the production cost, and reduced greatly the production cycle.This mold opens and closes the mold movement to conform to the design requirement completely, is suitable for the mass production. Key word: Handset battery charger outer covering, plastic injection mold, Pro/ENGINEER, AutoCAD 2007, a mold cavity. 目 录 中文摘要………………………………………………………………………………1 英文摘要………………………………………………………………………………2 目 录 …………………………………………………………………………………3 1.引言…………………………………………………………………………………5 2.工艺分析……………………………………………………………………………6 2.1 PS材料性能简介………………………………………………………………6 2.2产品分析 ……………………………………………