13万吨年中等分子量聚丙烯酰胺干燥设备设计.docVIP

1.3万吨/年中等分子量聚丙烯酰胺干燥设备设计  摘 要 本设计来源是通过在聚合物二厂聚合二车间实习，并且对合成聚丙烯酰整体生产工艺流程的分析和对其干燥设备进行分析，从文献、书籍和网络了解干燥器的发展和各类干燥器的优缺点。通过查阅有关设计流化床干燥器的中外文献，及有关聚丙烯酰胺的理化性质与合成方法，对卧式多室流化床干燥器进行设计。设计内容包括干燥器主体的工艺计算和干燥器附属设备的选型和计算。 本文较全面的的阐述聚丙烯酰胺干燥设备的工艺流程及原理，并对干燥器工进行设计，通过对干燥器的物料衡算、能量衡算，确定干燥器的底面积和高度，对干燥系统绘制带控制点的流程图及车间平面图，完成干燥装置装配图。经计算与校核，干燥器的设计结果基本符合要求 关键词：聚丙烯酰胺；干燥器；卧式多室流化床  Abstract This design source is through the two polymerization in polymers, and two workshop internship on synthesis of polypropylene acyl overall production process analysis and drying equipment for its analysis, from literature, books and network understand the development of drier and various kinds of dryer advantages and disadvantages. Through consulting relevant design fluidized bed drier Chinese and foreign documents, and relevant PAM physical and chemical properties and synthetic methods and the application of polyacrylamide development present situation and prospect of horizontal more comprehensive analysis, design room fluidized bed drier. Design content including dryer subject technical calculation and dryer accessory equipment selection and calculation. This paper comprehensively expounded of polyacrylamide drying equipment, and process flow and principle of dryer to carry on the design, through the work of material balance dryer is, energy can be determined, the bottom of drier area and the height of the drying system, drawing with the flow chart and control plan, complete drying device workshop assembly drawings. The calculation and checking, dryer design results basic meets the requirement Keywords: PAM; Dryer; Horizontal multi-oven fluidized bed 目 录 第一章 前言……………………………………………………………………………1 1.1 聚丙烯酰胺的发展…………………………………………………………………1 1.2 聚丙烯酰胺的种类………………………………………………………………1 1.3 聚丙烯酰胺的性质…………………………………………………………………2 1.4 聚丙烯酰胺的主要特点…………………………………………………………2 1.5 干燥器的分类与选择………………………………………………………………3 1.5.1 干燥器的分类……………………………………………………………3 1.5.2干燥器的选择……………………………………………………………4 第二章 设计内容概述…………………………………………………………………5 2.1 工艺原理和设计目的………………………