QTZ40塔式起重机臂架优化设计（含全套CAD图纸）.doc

买文档后送图纸，QQ 194535455 摘要 本次设计在参照同类塔式起重机基础上，对QTZ40型塔式起重机进行总体设计及吊臂的设计。在吊臂设计工程中，采用了有限元法对其进行分析计算，采用了ANSYS10.0软件进行分析。 按照整机主要性能参数，确定各机构类型及钢结构型式，主要确定了吊臂的结构参数，并按照吊臂端部加载、跨中加载及根部加载三种工况分析。通过对吊臂作适当的简化，应用ANSYS10.0软件建立吊臂有限元模型，施加各工况载荷，进行求解，进而可得各工况下各节点受力情况及各单元所受轴向力、轴向应力大小及各工况下吊臂的变形挠度大小，并能演示吊臂加载过程的动画，清晰的展现了各工况下吊臂的受力性能。 通过修改模型参数，对不同模型进行分析比较。由比较不同模型在相同工况下的受力状况及刚度状况，综合分析强度和刚度条件，可得出受力最为合理的一组模型参数，通过对此组参数下模型进行强度及刚度校核，进而获得吊臂的最终参数结果。 关键词：QTZ40型塔式起重机 吊臂 有限元分析 ANSYS10.0 Abstract Refers to the similar tower crane, this design is composed by the system design and the lazy arm design to the QTZ40 tower crane. In the lazy arm design progress, it has carried Finite Element method on the analysis computation, and used ANSYS10.0 software. According to the entire machine main performance parameter, various organizations type and the steel structure pattern has been determined. The design parameter of operating modes which are composed of nose increase, the cross center increase and the root increase. Through the suitable simplification to the lazy arm, the lazy arm finite element model is establishment applied ANSYS10.0 software, and then exerted various operating modes load, carried on the solution. Then ANSYS10.0 software can calculate various pitch points stress situation, various units receive the axial stress size, and the lazy arm distortion size under various operating modes. Also it can demonstrate the animation in the process of the lazy arm increase. It has clearly displayed the lazy arm stress performance under various operating modes. Through the revision for model parameter, the analysis comparison is carried on the different model. Because the stress condition and rigidity condition of different model is compared under the same operating mode, and the generalized analysis intensity and the rigidity condition is carried on, a most reasonable model parameter can be obtained, though the intensity and the rigidity examination regarding this model, then the final parameter result