多功能焊台设计（含全套CAD图纸）.doc

买文档后送图纸，QQ 194535455 摘 要 焊台的种类很多按照升降结构的不同，可分为直流焊机、交流焊机、电气焊台、气割焊台及摇臂式台等。多功能焊台采用电流驱动，整机由底座、焊臂、升降系统组成。 本文所介绍的多功能焊台最大焊接直径是1000mm，它有两部分组成：升降焊头机构和焊台底座。升降机构的操作控制是由涡轮蜗杆来完成的。这样的焊接升降台的设计通常根据设计参数要求，粗略估算剪叉尺寸，然后做出涡轮蜗杆的尺寸，从而进行涡轮蜗杆选型。由于升降机构需要各个方位都得达到，设计当中需要活动自如。解决的办法是通过用轴承和涡轮蜗杆来实现，确立一种方案，并根据需要，设计最优的长度，及对连接零件、滑动装置的选型等。在满足机构设计的基础上，对受力较大的机构进行强度和刚度的校核，检验是否满足设计要求。作为控制系统，涡轮蜗杆系统的设计很重要，这包括尺寸大小设计，涡轮蜗杆的选取及其他元件的选型等。最终完成多功能焊台的设计。本设计借鉴了相关的资料，采用了相关的标准，充分的吸收了前人的宝贵的经验。 关键词：升降机构、传动系统、固定机构、涡轮蜗杆机构、伸缩臂  ABSTRACT Scirssor Lift Conveyor Abstract : There are many types of lift table, according to the structure of the different movements ,which can be divided into scissors-lifts or shrink-lifts ,sleeve-lifts or shrink arm lifts and arm –folding lifts and so on . The atmospherric pressure actuation is used in atmospherric pressure lift table, and the whole machine was made of the main body, the atmospherric system and the control system. Maximal load capacity of logistic press described by this paper is 500 kg , it has two parts: this scissors fork and atmospherric pressure system. This operation of the scissors fork is under the control of atmospherric cylinder.Such atmospherric lifts are usually designed in accordance with the requirements of the design parameters, then the atmospherric cylinder thrust force is extracted by the sketchy estimate size.Thus the typle of the atmospherric cylinder can be sure. As the size of atmospherric cylinders and the positions for securing are different, it possibly have the interference in the design. The solution is to establish a programe through the analysis and comparison in the atmospherric cylinder layout.According to the need, we can design the optimal scissors fork, and select the connector of parts, sliding devices and so on. In the foundation of the design,the intensity and the rigidity examination to the large stress organization should bemade to examine whether that satisfy the design requirements. As the control system, atmospherric systems design is