A市某区排水工程规划设计和和污水处理厂工艺设计.doc

A市某区排水工程规划设计和污水处理厂工艺设计 摘 要 本设计主要包括两大部分： 第一部分：A市某区排水管道规划。 该城市采用分流制排水系统，即雨水和污水通过两个系统排除。 污水汇入城市污水处理厂进行集中处理，污水管道为了满足最小流速的要求，对于管道有最小坡度的规定，由于该城市地形由东北向西南下降，所以顺着坡度引水。最大程度减小了埋深，节约了成本。 为保证污水水力安全，本设计的排水管网采用雨水，污水分流制 。污水管网将家庭生活污水、工业废水、工业生活污水和其他排入污水管网的污水收集并送至污水厂处理；雨水管网则收集雨水，排入河流；城市污水含有大量的氮、磷和有机物，如处理不当将严重影响环境，所以必须设污水厂对其进行处理，以使出水达到国家排放标准。 第二部分：城市工业污水处理站的设计。 污水厂工艺选择了卡罗塞尔氧化沟和Cass工艺两种进行比较选择，同时从经济和工艺优越性两方面选择。本设计通过方案比较，最后确定了卡罗塞尔氧化沟工艺，这组工艺结合了高效，稳定，经济合理，自控程度高，运行管理方便等优点,并广泛运用于现在很多污水处理站。 关键词 排水管网；雨水管网；CASS工艺；卡罗塞尔氧化沟工艺 The Design on The Drainage of City A and A Wastewater Treatment Plant Abstract This design is drainage works of A Design elements include an urban drainage network and an urban sewage treatment in two parts. PART ONE The design of drainage works of city A。 This city take the design of the drainage network using rainwater, sewage triage system.To ensure the demand of the lest velocity , there are some provision about the gradient . Because the gradient of this city is declining from northeast to southwest . So , it will cost the lest because pipeline depend on the gradient . To ensure the safety of the sewage water, the design of the drainage network using rainwater, sewage triage system. Sewage pipe network of domestic sewage, industrial wastewater, the industrial sewage and other discharges into the sewer network sewerage and sent to the sewage treatment works. Net rainwater collects rainwater into the river. Urban sewage contains a lot of nitrogen, phosphorus and organic matter, such as improper handling will have a serious impact on the environment. So must put its sewage treatment plant, using water to reach the state emission standards. PART TWO The design of industry sewage treatment plant Wastewater treatment plant process selected Carlo Sal oxidation ditch technology and Cass two were chosen for comparison, and choose from two aspects superiority in economy and technology。Compare with many process and carrousel technology of economic and techn