第6章在Patran界面中建立Dytran模型及后处理的操作过程实例6.pptVIP

检查板元的法线方向: ? Finite Elements/Verify/Element/Normals/Draw Normal Vectors/Test Control=Display Only/Apply 从图中可以看出，网格中单元法线方向一致，指向上。 在板料几何面上创建网格种子点。步骤如下： Group/Post/选中“plate”/Apply Finite Elements/Create/Mesh Seed/Uniform /Number of Elements=40/Curve List=Surface 11:14.4 11:14.3/Apply 划分有限元网格： Finite Elements/Create/Mesh /Surface/Quad/ISOMesh/Quad4/Curve List=Surface 11:14/Apply 消除重复结点： Finite Element/Equivalence/All/Tolerance Cube/Equivalencing Tolerance=0.005/Apply 用MATRIG材料本构模型定义凸模的材料特性: Materials/Create/Isotropic/Manual Input/Material name=rigid_upper/Input Properties/Constitutive Model=Rigid(MATRIG)/Element Type=Shell/Density=7.8E-6/Elastic Modulus=2.1E8/Poisson Ratio=0.3/Ok/Apply 定义凸模的物理特性: Properties/Create/2D/Shell/Property Set Name=upper/Input properties/Material Name=rigid_upper /Shell Thickness=1./OK/Select Members = 拾取组“upper_die”中的所有几何面/Apply 用MATRIG材料本构模型定义凹模的材料特性: Materials/Create/Isotropic/Manual Input/Material name=rigid_upper/Input Properties/Constitutive Model=Rigid(MATRIG)/Element Type=Shell/Density=7.8E-6/Elastic Modulus=2.1E8/Poisson Ratio=0.3/Ok/Apply 定义凹模的物理特性: Properties/Create/2D/Shell/Property Set Name=upper/Input properties/Material Name=rigid_lower /Shell Thickness=1./OK/Select Members = 拾取组“lower_die”中的所有几何面/Apply 用MATRIG材料本构模型定义压边圈的材料特性: Materials/Create/Isotropic/Manual Input/Material name=rigid_upper/Input Properties/Constitutive Model=Rigid(MATRIG)/Element Type=Shell/Density=7.8E-6/Elastic Modulus=2.1E8/Poisson Ratio=0.3/Initial Vel. Of CG(Vy)=-1000./Ok/Apply 定义压边圈的物理特性: Properties/Create/2D/Shell/Property Set Name=binder/Input properties/Material Name=rigid_binder/Shell Thickness=1./OK/Select Members = 拾取组“binder”中的所有几何面/Apply 用SHEETMAT材料本构模型定义板料的材料特性: Materials/Create/3d Orthotropic/Manual Input/Material name=metal/Input Properties/Constitutive Model=Sheetmaterial(SHEEETMAT)/Elasticity Type=Isotropic/Yield Criterion Type=Normal Anisotropic/Hardening Rule Type=Normal Anisotropic /Density=8.413E-4/Elastic Modulus=1.E8/Poisson Ratio=0