- 1、原创力文档(book118)网站文档一经付费(服务费),不意味着购买了该文档的版权,仅供个人/单位学习、研究之用,不得用于商业用途,未经授权,严禁复制、发行、汇编、翻译或者网络传播等,侵权必究。。
- 2、本站所有内容均由合作方或网友上传,本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺!文档内容仅供研究参考,付费前请自行鉴别。如您付费,意味着您自己接受本站规则且自行承担风险,本站不退款、不进行额外附加服务;查看《如何避免下载的几个坑》。如果您已付费下载过本站文档,您可以点击 这里二次下载。
- 3、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等,请点击“版权申诉”(推荐),也可以打举报电话:400-050-0827(电话支持时间:9:00-18:30)。
查看更多
本科毕业论文
(20 届)
某四层商场半集中式空调系统设计
专业:建筑环境与设备工程
目录
摘 要 Ⅰ
1 绪论 1
1.1 设计目的 1
1.2 设计要求 1
2 工程概况和原始资料 2
2.1 工程概况 2
2.2 设计依据 2
3 负荷计算 3
3.1 冷负荷计算依据 3
3.2 湿负荷计算依据 5
3.3 冷负荷和湿负荷计算 5
3.4 负荷计算汇总 17
3.4 最大冷负荷计算 21
4 空调系统方案的确定 22
4.1 空调风系统的选取 22
4.2 空调水系统的选取 22
5 风机盘管加新风系统选型计算 24
5.1 风机盘管系统计算 24
5.2 风机盘管的选型 26
5.3 气流组织计算 27
5.4 新风机组选型 31
6 风管布置及水力计算 32
6.1 地下层风管水力计算 32
6.2 一层风管水力计算 43
6.3 二、三层风管水力计算 50
6.4 四层风管水力计算 57
7 水管布置及水力计算 64
7.1 计算最不利管段的沿程损失依据 64
7.2 计算最不利管段局部阻力损失依据 64
7.3 计算支管的沿程阻力损失和局部阻力 64
7.4 检查并联管路的阻力平衡 66
7.4 回水管压力验证 68
7.8 一层水管水利计算 69
7.9 二、三层水管水利计算 71
7.10 四层水管水利计算 73
8 冷源系统的确定及选型 76
8.1 方案的确定及可行性 76
8.2 冷水机组的选型 76
8.3 冷凝水管选择 77
9 膨胀水箱的选型 78
9.1 膨胀水量的计算 78
9.2 系统补给水量的计算 78
10 商场空调设计中的几个特殊性问题 79
结束语 80
致谢 81
[参考文献] 82
附 译文 83
摘 要
本设计对象是广州市某大中型商场的空调系统设计。该建筑位于广州,从地下一层到地上4层,总高度24 m,空调区域面积为12150m2。空间类型主要用与会展、购物,人流数密集。本论文的空调设计内容包括:半集中式空调风系统、空调冷却水系统、冷热源设计。主要内容在负荷计算的基础上,选择风机盘管加新风系统的方案,并进行气流组织计算、风管水力计算。风机盘管为卡式明装,新风不承担室内负荷A Design of Semi-Central Air Conditioning System in A Four–Story Mall
[Abstract] This design object of the thesis is the semi-central air conditioning system of a shopping mall in Guangzhou. There is a basement and four stories in the shopping mall which covers 12150 m2. It is mainly used for exhibitions and shopping. The contents of the design of air conditioning system include semi-central air conditioning system, cooling –water system and cold and heat sources. Based on the load calculation, the thesis will apply fan-coil and flesh air system, calculate air distribution and power of wind pipe. The fan coil is visible installation and the fresh air does not assume indoor load. The blended return and fresh air indoor will be sent out from double deflection grille. The cold source will apply air-water system and calculate power of water pipe, water chilling unit and choose expansion tank.
The last part of the thesis will reach a conclusion of the design, summarize problems for further study and put forwar
文档评论(0)