单片机电机调速控制器设计.docVIP

#includereg52.h 大学 #define uchar unsigned char #define uint unsigned int uchar table[]={0x44,0xde,0x62,0x52,0xd8,0x51,0x41,0xd6,0x40,0x50};//0xbf为小数点 uchar fenshi,fenge,miaoshi,miaoge,time_flag,change_flag,num,return_flag=1; uchar timer1_count,ss_flag; bit timer1_flag; sbit open=P1^3; sbit close=P1^4; sbit =P1^5; sbit we3=P1^6; sbit we4=P1^7; sbit beep=P3^7; void delay(uchar timers) { uchar i,j; for(i=0;i125;i++) { for(j=timers;j0;j--); } } void speaker(void) { uchar i,j; for(j=0;j250;j++) for(i=0;i250;i++) { beep=~beep; for(i=0;i250;i++); } beep=1; //防止结束时候是低电平 } void timer0_init() { TMOD = 0x11; ET0=1; ET1=1; TH0 = 0x20;//大约50ms TL0 = 0x00; TH1=0x10; TL1=0; TR0=1; EA=1; } void smg_Reveal() { /////第一个按键///// we1=0; we2=1; we3=1; we4=1; //P2=table[fenshi]; if(num!=4||ss_flag==0) { P2=table[fenshi]; } else if(num==4ss_flag==1) { P2=0xff; } delay(2); if(we0==0) { delay(2); while(!we0); if(return_flag) { return_flag=0; TR0=0; change_flag=1; num=1; TR1=1; } else if(!return_flag) { return_flag=1; TR0=1; change_flag=0; num=0; TR1=0; } speaker(); } ///////第二个按键///// we1=1; we2=0; we3=1; we4=1; //P2=table[fenge]0xbf; if(num!=3||ss_flag==0) { P2=table[fenge]0xbf; } else if(num==3ss_flag==1) { P2=0xff; } delay(2); if(change_flag) { if(we0==0) { delay(2); while(!we0); num++; if(num4) { num=1; } speaker(); } } //////第三个按键////// we1=1; we2=1; we3=0; we4=1; //P2=table[miaoshi]; if(num!=2||ss_flag==0) { P2=table[miaoshi]; } else if(num==2ss_flag==1) { P2=0xff; } delay(2); if(change_flag) { if(we0==0) { delay(2); while(!we0); switch(num) { case 1:if(miaoge9){miaoge++;}break; case 2:if(miaoshi5){miaoshi++;}break; case 3:if(fenge9){fenge++;}break; case 4:if(fenshi5){fenshi++;}break; } speaker(); } } ///////第四个按键////// we1=1; we2=1; we3=1;