TL-C型凸轮轴形面误差综合测量仪技术协议.docVIP

TL-500C型凸轮轴形面误差综合测量仪 技术协议 Technical Protocol of the TL-500C Type Comprehensive Camshaft Profile Surface Error Measuring Instrument 测量原理： 该仪器采用极坐标测量原理，由精密滚动主轴系统和高精度光栅编码器生成被测量凸轮轴回转角度的圆分度，由径向精密滚动导轨和长光栅传感器在径向方向上扫描凸桃形面每一分度对应的径向凸桃升程，测量评值软件根据被测量凸桃的理论升程表测量出该凸桃的升程和相位角误差。（原理如图示）1. Measuring Principle This instrument adopts the pole coordinates measuring principle. The precision rolling main shaft system and the high accuracy encoder generate the round graduation of the measured camshaft turn angle, the radial precision rolling guideway and the linear encoder scan in the radial direction the radial ascending stroke of the peach-shaped cam corresponding to each graduation on the peach-shaped cam profile surface，the measuring and value-evaluation software measures the ascending stroke error and phase angle error of this peach-shaped cam according to the theoretical lift table of the measured peach-shaped cam. (See the Sketch below.) 测量原理图 测量原理图 Sketch of the measuring principle2.技术指标： 可测量凸轮轴轴向长度------------------------------ 500 mm 测头径向测量行程------------------------------------ 60 mm 主轴回转半径------------------------------------------ 70 mm 最大承载重量------------------------------------------ 3 0 Kg 测头径向分辨率--------------------------------------- 0.0001 mm 主轴回转分辨率--------------------------------------- 0.0005 ° 主轴系下顶尖径向跳动 ----------------------------- 0.0015mm 测量重复性------------------------------ 升程 0.003 mm，角度 3′ 示值误差--------------------------------- 升程±0.003 mm，角度±5′ 2. Specifications: Measurable axial length of the camshaft ----------------------- 500mm Radial measuring distance of the measuring head ------------ 60mm Turn radius of the main shaft ------------------------------------ 70mm Maximum permissible weight ----------------------------------- 30kg Radial resolution of the measuring head ----------------------- 0.0001mm Turn resolution of the main shaft ------------------------------- 0.0005?