超高强贝氏体钢再结晶与应变秀导析出研究.pdfVIP

超高强贝氏体钢再结晶与应变诱导析出研究 易 敏 熊化冰 林志峰 陈 涛 （首钢总公司技术研究院，北京 100041） 摘 要 利用热模拟技术研究了不同热变形温度条件下双道次变形，及不同道次间隔时间等工艺参数对一种Nb 微 合金化超高强贝氏体钢再结晶规律的影响。根据静态再结晶软化率曲线图，和观察双道次热变形后奥氏体晶粒随着间 隔时间的变化，研究了应变诱导析出Nb(CN)与热变形中奥氏体的再结晶相互作用规律。结果表明，1000℃至900℃的 温度范围内，由于发生应变诱导析出，再结晶过程被延迟，在本试验的道次间隔时间内都为部分再结晶，同时随着变 形温度的降低，经过双道次累计应变后，发生完全再结晶，奥氏体晶粒明显细化。 关键词 Nb 微合金 形变诱导析出 静态再结晶 超高强贝氏体钢 Investigation of Recrystallization and Strain Induced Precipitation in Ultra High Strength Bainitic Steel Yi Min Xiong Huabing Lin Zhifeng Chen Tao (The Research Institute of Technology ，Shougang Group，Beijing ，100041) Abstract The influences of different deformation temperatures and holding times between passes on recrystallization rule of a ultra high strength bainitic steel microalloyed with Nb after two-pass deformation was investigated by thermo-simulation test ．According to static recrystallization softening rate curve and austenite grain dimension after two-pass deformation ，the interaction of the thermal-deformed austenite recrystallization and strain induced precipitation of Nb(CN) was studied ．The results indicated that within 1000℃ and 900 ℃ temperature range ，due to strain induced precipitation ，austenite recrystallization was delayed during the holding time between passes ，partial recrystallization was observed ．In the mean time，after accumulative strain of two-passes，the austenite was completely recrystallized ，with the decrease of deformation temperature，the austenite grains were refined distinctly ． Key words Nb microalloy,strain induced precipitation,recrystallization,ultra high strength bainitic steel 铌微合金化技术和铌微合金化钢的研究开发始于 20 世纪50 年代末 60 年代初，上世纪80 年代以后，铌在 板带材的物理冶金知识开始应用到