模具采购合同范本.docVIP

PURCHASE CONTRACT of Plastic Mold 注塑模具采购合同 BETWEEN The Buyer（Party A）: THE BUYER Address:地址： Postcode邮编： Tel电话： Fax传真：AND The Seller (Party B)： 卖方（乙方)Postcode邮编： Tel电话： Fax传真： Place: 签约地点： Signing Date: ___________________ 签约日期: After friendly negotiation, Party A and Party B agree to reach this contract as follows for complying with. 甲乙双方经友好协商，甲方和乙方一致同意签订以下合同，以便共同遵守。 Object:合同标的物： /No 产品编号/Part No 注塑产品规格/plastic parts spec 模具数量/Quantity of molds 模穴数/Mold Cavity 模具含17%税价格（元)/Tooling cost with 17% vat(RMB) 1 2 3 4 5 Total 乙方根据甲方提供的注塑产品要求负责设计制造模具. 上述模具单价为人民币含17%税, 包括了模具设计,生产,试模,以及产品在甲方验收合格前的所有相关费用. Party B should design and produce the Molds. The unit price for the molds mentioned above based on RMB(included 17% vat), which includes the design, produce ,trial run cost and any other cost about the Molds before the plastics sample have been approved by Party A. 2. Quality Standard: the quality of goods shall accord with the standard as follows: 质量标准：本合同标的物需符合以下质量标准：（可以多选） ccording with state standard and industry standard ，if they are not the same, the higher shall prevail 符合国家标准和行业标准，若两者不一致以高者为准 in the contract 合同中的模具必须可以生产至少50万模次的合格产品 The plastic products which are produced by the Molds need to meet the requirement of Party A, refer to Appendix1 standard of plastic products. 该模具生产的注塑产品应符合甲方的要求，标准。3．property of molds will transfer to Party A after inspection and acceptance. Party A will decide to lease the Molds to Party B , then Party B shall use them to produce plastic parts in their own factory. In period of lease term, the damage and destroy risk of molds is borne by Party B , Party B should keep the molds in good condition, and bear any cost of maintain. 经甲方验收合格后, 模具的所有权即归甲方所有.甲方视情况将模具寄存在乙方工厂并且委托乙方进行注塑加工.租借期内,模具损坏和灭失的风险由乙方承担,乙方有义务保证模具完好,如有损坏需立即维护并且支付相应费用. 3.2 The Molds are the property of Party A, Party A can carry part of or all of them back anytime. 模具的所有权为甲方, 甲方有权随时收回部分或者全部模具. 3.3 Party B shall mark all mol