stm8C语言例程.docVIP

（1）;名称 ：流水灯 ;描述 : ；先从上至下点亮所有的LED，再逐个点亮单个LED ;***********************************************************/ #include stm8s105s4.h #define uchar unsigned char #define uint unsigned int uchar table[]={0xfe,0xfd,0xfb,0xf7,0xef,0xdf,0xbf,0x7f}; //存放点亮单个LED的代码 void DelayMS(uint s) //延时子函数，约延时1ms { uint i; for(s;s0;s--) for(i=0;i500;i++); } void init(void) //stm8初始化函数 { PB_DDR = 0xff; PB_CR1 = 0xff; // 将PB设置成推挽输出 PB_CR2 = 0x00; CLK_SWR = 0xE1; //选内部高速时钟作为主时钟 CLK_CKDIVR = 0x08; //将CPU主频设置为2M（STM8默认的就是内部高速时钟的八分频，即2MH，这里只是告诉大家设置方法） } void main() { uchar i; init(); while (1) //无限循环 { PB_ODR = 0xff; //先将所有的LED关闭 for(i=0;i9;i++) //一开始是所有的LED熄灭，再逐点亮所有LED，共九种状态 { DelayMS(500); //延时500毫秒 PB_ODR=1; //将PB_ODR向左移动一位，逐渐点亮所有LED } for(i=0;i8;i++) { PB_ODR=table[i]; //将table中的数依次赋给PB_ODR ，从上至下依次点亮LED DelayMS(500); } } } 中断向量： /* BASIC INTERRUPT VECTOR TABLE FOR STM8 devices * Copyright (c) 2007 STMicroelectronics */ typedef void @far (*interrupt_handler_t)(void); struct interrupt_vector { unsigned char interrupt_instruction; interrupt_handler_t interrupt_handler; }; @far @interrupt void NonHandledInterrupt (void) { /* in order to detect unexpected events during development, it is recommended to set a breakpoint on the following instruction */ return; } extern void _stext(); /* startup routine */ struct interrupt_vector const _vectab[] = { {0x82, (interrupt_handler_t)_stext}, /* reset */ {0x82, NonHandledInterrupt}, /* trap */ {0x82, NonHandledInterrupt}, /* irq0 */ {0x82, NonHandledInterrupt}, /* irq1 */ {0x82, NonHandledInterrupt}, /* irq2 */ {0x82, NonHandledInterrupt}, /* irq3 */ {0x82, NonHandledInterrupt}, /* irq4 */ {0x82, NonHandledInterrupt}, /* irq5 */ {0x82, NonHandledInterrupt}, /* irq6 */ {0x82, NonHandledInterrupt}, /* irq7 */ {0x82, NonHan