用作模板的GRC平板的干缩_湿胀性能试验研究.pdfVIP

GRC 、* 宋小软 于清缘 曲俊义 (北方工业大学 建筑工程学院 北京 100041) ( 河北省建设厅 石家庄 050001) : 通过正交试验,对影响GRC 平板干 性能和湿胀性能的诸多因素及其水平进行了优选, 分别找 出了影响显著的主要因素及其影响规律和机理, 通过计算分析, 给出各影响因素的主次顺序, 计算出干 性 能和湿胀性能与诸因素水平之间的关系。根据试验结果和理论计算结果,通过综合平衡分析, 从中优选出干 性能和湿胀性能都较优的材料配比组合, 并进行理论值计算。研究成果为拟用作模板的GRC 板的设计和 使用提供了试验依据。 : GRC 板 干 率 湿胀率 正交试验 EXPERIMENTAL STUDY ON DRY2 SHRINKAGE AND BULKING FACTOR OF GRC PLATE USEDFOR FORMWORK Song Xiaoruan Yu Qingyuan (Department of Civil ngineering, North2 China University of Technology Beijing 100041) Qu Junyi (Hebei Province Construction Office Shijiazhuang 050001) Abstract : Some factors influencing dry2 shrinkage factor and bulking factor of GRC plate and the corresponding levels were studied, and some key factors and influencing laws were found through orthogonal experiment. The influence sequence of these key factors and relationship with dry2 shrinkage and bulking performance were presented by theoretical analysis. According to experimental,theoretical results and equilibrium analysis, several matched groups that could brought good dry2 shrinkage and bulking performance were obtained, and the corresponding performance indexes were estimated. An experimental and theoretical gist for design and practical application of GRC plate desired to used for formwork could be provided. Key ords : glass2 fiber reinforced cement plate dry2shrinkage factor bulking factor orthogonal experiment 玻璃纤维混凝土 GRC( glass2fiber reinforced 采用正交方案进行试验设计。根据初步研究结 cement)板用作建筑施工模板的前提条件是必须具