毕业设计（论文）-基于Multisim的数字时钟的设计及仿真.doc

基于Multisim的数字时钟的设计及仿真 摘 要 仿真的数字时钟秒、分、时随时校正分钟和小时， 关键词：，，  Simulation Discussion of Digital Clock Based on Multisim Author: Huang Sheng Tutor: Si Xiao--ping Abstract Along with the development of Electronic Design Automation(EDA)，a new way of the electronic circuit design and experiments is created by using virtual instruments and components on computers．Multisim a software to be able to use this way, because of its intuitive and convenient features of its electronic design with a wide range of applications. Multisim software can be carried out in the simulation, the actual operation to avoid the inconvenience of the complicated and, at the same time to save the experimental equipment, help to learn, and thus apply what they have learned. And go figure, when the clock has precision, school and convenient design and easy to use features, to achieve timing and time functions, have been widely used. Through this figure the simulation clock to help recognize the role of its software, in-depth analysis of its principles, to help understand the working principle of the digital clock. For design and simulation with Multisim software in the digital clock. We first created Multisim software digital clock circuit diagram of the total. And then use the softwares simulation features in the simulation. Correct simulation of the digital clock should have seconds, sub, when the decimal figures, can be corrected at any time minutes and hours, when the bell when the whole point to carry out the whole time, but also can be set from time to time. Key word: EDA，Simulation，Digital Clock 目 录1绪论 1 1.1 课题背景及目的 1 1.2 国内外研究状况 2 1.3 论文的构成及研究内容 2 2设计方案 4 3 Multisim 10软件介绍 6 3.1 Multisim 10软件简介 6 3.2 Multisim 10软件功能 6 3.3 Multisim 10软件发展 6 3.4 Multisim 10软件分析工具 7 3.5 Multisim 10仿真的基本步骤 7 3.6 Multisim 10意义 8 4数字时钟设计及仿真分析 9 4