多孔介质填充方式对通道传热效果影响数值模拟.pdfVIP

J12 多孔介质填充方式对通道传热效果影响的数值模拟 张红军 邹正平 叶建 刘火星 （北京航空航天大学能源与动力工程学院，航空发动机气动热力国家级重点实验室，北京 100191） 摘要：本文基于结构/非结构同位网格的SIMPLE算法发展了多孔材料内部流动和传热计算程序，其中多孔区域动 量方程采用Brinkman-Forchheimer拓展Darcy模型，能量方程采用局部热平衡模型。并对恒热流边条下平行通道沿 中心及壁面区域填充多孔材料时的流动和传热特性进行了数值分析与比较，这两种填充方式分别对应于边界流传 热强化和核心流传热强化。研究结果表明，沿通道中心部分填充多孔材料时，会在边界区域重新构造出更薄的热 边界层；而沿通道壁面填充多孔材料时，在不考虑接触热阻的情况下，多孔材料可以被看作平行通道壁面的扩展， 与光通道相比，两种多孔材料填充方式均能有效地强化换热，但同时也造成比较大的压降，其性能与多孔材料填 充方式以及填充比有很大的关系。在本文所研究的条件下，沿管壁填充多孔材料有着更好的综合换热性能。 关键词：多孔介质；填充方式；边界流；核心流；传热强化 中图分类号：TK124 文献标识码：A Numerical investigation to heat transfer enhancement of parallel-plate channel with different porous media insert modes ZHANG Hong-jun, ZOU Zheng-ping, YE Jian, LIU Huo-xing (National Key Laboratory of Science and Technology on Aero-Engines, School of Jet Prop., Beihang Univ., Beijing 100191, China) Abstract: In this paper, based on the SIMPLE scheme on structured/unstructured collocated meshes, the code used for the prediction of the flow and heat transfer characteristics in porous media domain was developed, where the momentum equations were formulated by Darcy-Brinkman-Forchheimer model; and the thermal non-equilibrium model was adopted for energy equation. Then the heat transfer characteristics of parallel-plate channel with porous inserts along the channel center and wall region, which correspond to the core flow heat transfer and boundary flow heat transfer, were analyzed under the conditions of constant heat flux respectively. The results indicate that the thinner heat boundary layer would be constructed near the wall region with porous insert along channel center; and the porous media