思科2950.docVIP

2950交换机 简明配置维护手册 配置端口 配置一组端口 命令 目的 Step?1? configure terminal 进入配置状态 Step?2? interface range {port-range} 进入组配置状态 Step?3? 可以使用平时的端口配置命令进行配置 Step?4? end 退回 Step?5? show interfaces [interface-id] 验证配置 Step?6? copy running-config startup-config 保存 当使用interface range命令时有如下的规则: 有效的组范围: vlan从1 到4094 fastethernet 槽位/{first port} - {last port}, 槽位为0 gigabitethernet槽位/{first port} - {last port},槽位为0 port-channel port-channel-number - port-channel-number, port-channel号从1到64 端口号之间需要加入空格，如：interface range fastethernet 0/1?–?5 是有效的，而interface range fastethernet 0/1-5 是无效的. interface range 命令只能配置已经存在的interface vlan 所有在同一组的端口必须是相同类别的。 见以下例子: Switch# configure terminal Switch(config)# interface range fastethernet0/1 - 5 Switch(config-if-range)# no shutdown Switch(config-if-range)# *Oct 6 08:24:35: %LINK-3-UPDOWN: Interface FastEthernet0/1, changed state to up *Oct 6 08:24:35: %LINK-3-UPDOWN: Interface FastEthernet0/2, changed state to up *Oct 6 08:24:35: %LINK-3-UPDOWN: Interface FastEthernet0/3, changed state to up *Oct 6 08:24:35: %LINK-3-UPDOWN: Interface FastEthernet0/4, changed state to up *Oct 6 08:24:35: %LINK-3-UPDOWN: Interface FastEthernet0/5, changed state to up *Oct 6 08:24:36: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/05, changed state to up *Oct 6 08:24:36: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/3, changed state to up *Oct 6 08:24:36: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/4, changed state to up 以下的例子显示使用句号来配置不同类型端口的组: Switch# configure terminal Switch(config)# interface range fastethernet0/1 - 3, gigabitethernet0/1 - 2 Switch(config-if-range)# no shutdown Switch(config-if-range)# *Oct 6 08:29:28: %LINK-3-UPDOWN: Interface FastEthernet0/1, changed state to up *Oct 6 08:29:28: %LINK-3-UPDOWN: Interface FastEthernet0/2, changed state to up *Oct 6 08:29:28: %LINK-3-UPDOWN: Interface FastEthernet0/3, changed state to up *Oct 6 08:29:28: %LINK-3-UPDOWN: Interface G