StandardTestMethodforBrittlenessTemperatureof：脆性温度的标准试验方法.pdfVIP

Designation: D 746 – 07 Standard Test Method for Brittleness Temperature of Plastics and Elastomers by Impact1 This standard is issued under the fixed designation D 746; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (e) indicates an editorial change since the last revision or reapproval. 1. Scope* E 77 Test Method for Inspection and Verification of Ther- 1.1 This test method covers the determination of the tem- mometers perature at which plastics and elastomers exhibit brittle failure E 608/E 608M Specification for Mineral-Insulated, Metal- under specified impact conditions. Two routine inspection and Sheathed Base Metal Thermocouples acceptance procedures are also provided. E 1137/E 1137M Specification for Industrial Platinum Re- sistance Thermometers NOTE 1—When testing rubbers for impact brittleness use Test Methods 2.2 ISO Standard: D 2137. ISO 974 (E) Plastics—Determination of the Brittleness 1.2 The values stated in SI units are to be regarded as the Temperature by Impact3 standard. 2.3 ASTM Adjuncts: 1.3 Due to the potential safety and environmental hazards