（本科）毕业论文—慢步卷扬机传动装置设计.docVIP

本科毕业设计（论文） 题目：慢步卷扬机传动装置设计 教学单位： 机电工程系 专 业： 机械设计制造及其自动化 2012年5月 摘要 卷扬机广泛应用建筑、水利、冶金、起重作业。卷扬机又称绞车，是起重、垂直运输机械的重要组成部分，配合井架、桅杆、滑轮等辅助设备，用来提升物料、安装设备。电动卷扬机由电动机、联轴节、制动器、齿轮箱和卷筒组成，共同安装在机架上。电动卷扬机又可称为电动葫芦。对于起升高度和装卸量大，工作繁忙的情况下，要求调速性能好，特别要空钩能快速下降。对安装就位或敏感的物料，要能以微动速度下降卷扬机包括快速卷扬机和慢速卷扬机，仅能在地上使用，它以电动机为动力，经弹性联轴节，三级封闭式齿轮减速器，牙嵌式联轴节驱动卷筒，采用电磁制动。该产品通用性高、结构紧凑、体积小、重量轻、起重大、使用转移方便，被广泛应用于建筑、水利工程、林业、矿山、码头等的物料升降或平拖，还可作现代化电控自动作业线的配套设备。尽管其应用非常广泛,但在实际应用过程中目前仍存在着许多急待解决的问题普遍存在的不足是：体积大、过载能力差、噪音大、效率低、使用寿命短、工作不够安全可靠等，有些产品还已列入国家淘汰产品开展机设计、性能分析及应用研究， 具有较大的实用价值和重要的现实意义性能分析通用性Abstract The widely applied in construction, water conservancy, metallurgy, lifting operation. Hoist and winch, is an important part of lifting, vertical transport machinery, with the derrick, maist is composed of motor, coupling, brake, gear box and reels, mounted on the frame. Electric hoist is also known as electric hoist. For lifting height and loading amount is large, busy with work, request good speed performance, especially to the empty hook to the rapid decline in. The installation or sensitive material, to be able to decrease the speed of fast hoist winch fretting and slow winch, can only be used on the ground, it takes the motor as power, through an elastic coupling, three closed type gear reducer, tooth type coupling drive drum, using electromagnetic brake. This product is high universality, compact structure, small volume, light weight, big, use convenient, it is widely used in construction, water conservancy, forestry, mining, port materials such as lifting or flat mop, ancillary equipment can be automatic line for modern electronic. Despite its very wide application, but in the actual application process still exist many urgent problems to be solved, the common problems are: large volume, poor overload capacity, large noise, low efficiency, short service life, work is not safe, some products also has been included in the national phase-out products, carry out analysis and Research on Application of ho