环锭纺细纱机导纱动程探讨_李德州.pdfVIP

38 1 2010 1 Co tton Text ile T echno logy 11 11 李德州 ( ) : 探讨加大环锭纺细纱机导纱动程的可行性分析了环锭细纱机导纱动程的作用及制约因素, 对 条在胶辊表面不同位置时胶辊握持力进行了测试分析, 并在 7 个品种上进行了导纱动程从传统的 6 mm~ 9 mm 加大到 15mm~ 18 mm 的对比试验结果表明, 适当加大导纱动程, 不会影响成纱质量, 且可以延长胶辊使 用寿命, 一个复磨周期延长 3 个月~ 4 个月要精心做好导纱动程调整工作,并注意将导纱线速度控制在 4mm / m in以内 : 细纱机; 导纱动程;胶辊; 抗绕性;条干; 纱疵; + TS103. 23 1. 1 B 1001-7415( 2010) 01-0011-04 : : : D iscussion of Ring Spinning Fram e Guiding Travel L i D ezhou ( Jiangsu ueda Textile Group Stock Co. , L td. ) Abstract Feasibility of increasing ring spinning frame guiding travelwas discussed. Function and restraining fac- tors of ring spinning frame guiding travelwere analyzed. G ripping force of rubber-covered rollwas tested and analyzed as fiber strand laid in different rubber-covered rollsurface position. Guiding travelwas contrasted and tested on seven prod- ucts from 6mm~ 9mm to 15mm~ 18mm. The result show s that yarn qualityw illnotbe effectedwhen guiding travel is increased properly, while rubber-covered roll lifetmi e could be extended, one re-regrinding period could be extended 3 to 4months. Guiding travel adjustment should be done carefully and guiding linear speed should be controlled under 4 mm /m in. K ey W ords Spinning Frame, Guiding T rave,l Rubber-covered Rol,l Ant-ientangling, Evenness, arn Defect , ,, , , , 1 ,, , , , , , , , 6 mm~ 9 mm , ,