92装配图的表达方法.pptVIP

General representation 一般表达方法 Conventional representation 规定画法 Special representation 特殊画法 Special representation 特殊画法 Special representation 特殊画法 Special representation 特殊画法 Simplified representation 简化画法 本 小 节 结 束 * * Representation Methods of Assembly Drawings 装配图的表达方法 General representation 一般表达方法 Conventional representation 规定画法 Special representation 特殊画法 Simplified representation 简化画法 请点击相应标题显示其内容 All 　the 　above-mentioned representations are applied to the assembly 　drawing,　 including 　views, sectional views, cuts, and simplified representations. 前面所介绍的各种表达方 法均适用于装配图，包括：视图、剖视、断面、简化画法等。 请点击标左键显示后面内容 If the screwed fastening piece and solid piece are longitudinally sectioned and the cut plane goes through the center of symmetry, these parts are represented as though they were not sectioned. 对于螺纹紧固件及实心件若按纵向剖切且剖切平面通过其对称中心时，这些零件按不剖画出。 Section lines in two contiguous metal parts must be in opposite directions or unequally spaced, while section lines of the same part must be consistent in different views. 两个相邻金属零件的剖面线应方向相反或间距不同，而同一零件的剖面线在各个视图中应保持一致。 2. Representing contact surfaces and fitting surfaces of two parts. 零件接触面与配合面的画法 1. Representing section lines 剖面线的画法 3. Representing fastening pieces and solid pieces紧固件及实心件画法 The contact surface or fitting surface of two parts is represented as a line, while the non-contact surface or non-fitting surface is represented as two lines even small clearance. 两个零件的接触面或配合表面只画一条线，而非接触面或配合表面 之间有间隙处应画成两条线。 请点击鼠标左键显示后面内容 If the structure of a certain part is not clearly represented and will thus affect the understanding of its fitting relationship and function, the part must be drawn separately and marked with “xx direction” near the corresponding view indicating with arrows and capital letters the projection direction. 当某个零件的结构未表达清楚，且对理解配置关系或部件功能有影响时, 应单独画出该零件, 并在其上方注明 “零件××”, 在相应视图附近用箭头指明投射方向, 并注明相应的大写字母。 To represent the int