钨钼渗铜材料的力学性能与组织研究.pdfVIP

21 3 Vol.21 No.3 2011 6 POWDER METALLURGY INDUSTRY Jun. 2011 , , , , ( , 100081) : 本文对不同成分配比和不同骨架密度钨钼渗铜材料的力学性能和断口形貌进行 分 析和研究结果表明: ( 1) 对于相同或相近骨架密度材料, 本实验成分范围内的钨钼渗铜材料 在高温下固溶强化效果显著,骨架密度为 84%, 当Mo 含量为 10% (质量分数) 时, 800 和 1200 的强度分别达到 330 MPa 和215 MPa, 与钨铜材料相比, 强度提高 10%, 密度降低 8% Mo 含量增加, 强度下降; 对于相同成分配比材料, 骨架相对密度增大, 强度提高(2) 同 水平骨架密度材料,Mo 含量增加, 晶粒尺寸减小, 沿晶断口比例增加; 相同成分配比材料, 骨 架相对密度增大, 晶粒尺寸增大, 解理断裂比例增加 : 钨钼渗铜材料; 强度;微观组织 : TF1245 : A : 1006- 6543(2011)03- 0006- 05 ESEA CH ON T HE MECHANICAL P OPE TIES AND MIC OST UCT U E OF W-Mo-Cu COMPOSIT ES TANG Liang-liang,KUANG Yong-geng,CHEN Fe-i xiong,ZHANG ao-hong, Gan Le (CIS I, Advanced T echnology and Materials Co,Ltd, Beijing 100081, China) Abstract:T he mechanical properties and fracture morphology of W-Mo-Cu composite in dif- ferent Mo content and skeleton densities were studiedT he results show as followsFor the materials of same or similar skeleton density, Solid solution strengthening effect of the W- Mo-Cu composites in this paper is remarkable at high-temperatureCompared with the W-Cu materials,at 84% of skeleton density and 10wt% mass fraction of Mo content, the high-tem- perature strength are 330 MPa and 215 MPa at 800 and 1200 respectivelyT he strength increases about 10% and the density decreases about 8%The strength decreases with incre- ment of Mo contentT he fracture morphology shows that crystal size decreases with incre- ment of Mo content, but the proportion of intergranular increases at similar skeleton densi- tyFor the same component materials, crystal size and the proportion of transgranular in- crease with increasing of skeleton density Key words:Copper infilt