斯里兰卡普特拉姆1×300MW 机组DEH系统设计说明书.doc

1. 工程概况Overview of project 300MW机组系哈尔滨汽轮机有限责任公司设计生产的N300-16.7/538/538型亚临界一次中间再热、高中压合缸单轴双缸双排汽凝汽式汽轮发电机组，系统为单元制热力系统。 300MW汽轮机采用高压主汽门方式冲转，转速达到2900RPM时切换到高压调门控制升速、带负荷。每台机组配有两个高压主汽门（TV）、六个高压调门（GV）、两个中压主汽门（RSV）和两个中压调门（IV）。 机组启动运行方式： 定－滑－定运行，高压缸启动 负荷性质： 带基本负荷，可调峰运行 周波变化范围： 48.5～50.5Hz 旁路形式及容量： 30％B-MCR高低压串联简易旁路 机组额定出力： 300MW 主汽阀前额定蒸汽压力： 16.7MPa（a） 主汽阀前额定蒸汽温度： 538℃ 主汽门前蒸汽流量： 889.87T/H 中联门前蒸汽压力： 3.228MPa（a） 中联门前蒸汽温度： 538℃ 中联门前蒸汽流量： 741.76T/H 抽汽压力： 0.245～0.785Mpa 额定背压： 4.5kPa（a） 机组工厂编号： 73B 300MW汽轮机调节系统为高压抗燃油型数字电液调节系统（简称DEH），电子设备采用了上海西屋控制系统有限公司的OVATION系统，液压系统采用了哈尔滨汽轮机厂有限责任公司成套的高压抗燃油EH装置。 本说明书仅涉及DEH电气部分，液压部分请参考相关资料。 The steam turbine, type N300-16.7/538/538, manufactured by HTC is tandem compound, single reheat, regenerative, double exhaust, condensing, multi-cylinder design with combined HP-IP and separate LP casing, 3000 rpm speed, directly coupled with Generator. One boiler feeding one steam turbine thermodynamic system is applied to the power plant. The steam turbine rolls up and accelerates controlled by throttle valves (i.e. TV control mode). At 2900 rpm, control of speed is transferred from the throttle valves (TV control mode) to the governor valves (GV control mode). Each unit is equipped with two throttle valves (TV), six governor valves (GV), two reheat stop valves (RSV) and two interceptor valves (IV). Start up and operation mode: be capable of start up on TV control mode and operation on constant pressure-sliding pressure-constant pressure mode. Load carrying: be capable of operation on rated load or on peaking load service either. Tolerant frequency swing rang: 48.5~50.5 HZ. Bypass configuration and size: 30%-MCR HP and LP simplified bypass in series. Rated load: 300MW Rated inlet steam pressure of main stop valve (MSV, i.e. TV): 16.7MPa (a) Rated inlet steam temperature of main stop valve: 538 ℃ Inlet steam flow of main stop valve: 889.87 T/H Extraction steam pressure: 0.245~0.785MPa Inlet steam pressure of reheat stop valve (RSV): 3.2