汽车实用英语课件：Unit 1.pptVIP

Practice — Maintenance Manual Reading ? The service technician should also wear a face shield, and a fiberglass hook should be in the area and used to move a technician in the event of electrocution（触电）. The high-voltage shutoff switch is located in the rear of the vehicle under the right-side carpet（地毯）. Rotate the handle to the “service shipping” position, lift it out to disable the high-voltage circuit, and wait 5 minutes before removing high-voltage cables. Practice — Maintenance Manual Reading 3. HONDA CIVIC To totally disable the high-voltage system on a Honda Civic, remove the main fuse (labeled number 1) from the driver’s-side underhood fuse panel. This should be all that is necessary to shut off the high-voltage circuit. If this is not possible, then remove the rear seat cushion and seat back. Remove the metal switch cover labeled “up” and remove the red locking cover. Move the “battery module switch” down to disable the high-voltage system. Practice — Maintenance Manual Reading 4. CHEVROLET SILVERADO/GMC SIERRA PICKUP TRUCK The high-voltage shutoff switch is located under the rear passenger seat. Remove the cover marked “energy storage box” and turn the green service disconnect switch to the horizontal position （水平位置）to turn off the high-voltage circuits. Practice — Maintenance Manual Reading Do not touch any orange wiring or component without following the vehicle manufacturer’s procedures and wearing the specified personal protective equipment. Warning! Thank you! Practice — Maintenance Manual Reading NOTE! Use a steel wire brush only on steel or iron components. If a steel wire brush is used on aluminum or copper-based metal parts, it can remove metal from the part. The grinding stone end of the bench grinder can be used for the following: ? Sharpening blades and drill bits（钻头） ? Grinding off the heads of rivets（铆钉） or parts ? Sharpening sheet metal parts for custom fitting（自制管件） Task1.