汽车实用英语课件：unti 5.pptVIP

Learning Preparation（学习准备） windshield 风窗玻璃 disengage 分离 mesh 啮合 tape 卷尺，胶带 scrape 刮痕，擦伤 wiper 刮水器，电刷 fasten 紧固 nut 螺帽，螺母 Key terms: Step 1 A maintenance case is provided; Step 2 Learn the process of wipers/washer system inspection via a maintenance manual; Step 3 Require students to grasp the key terms in this task; Step 4 Try to describe the process of wipers/washer system inspection; Step 5 Students read relative material; Step 6 Assessment Plan and Implement （计划与实施） ( ) 1. Operate the wiper and stop the windshield wiper motor assy at the automatic stop position before replacement. ( ) 2. Do not fold down the front wiper arm with the front wiper blade being removed from it. ( ) 3. Screwdriver is used to disengage the cowl top ventilator louver. ( ) 4. The torque of installing the windshield wiper motor is 7.5Nm. Assessment and Feedback （评价与反馈） True or False ( ) 5. We should install the windshield wiper link assy before fitting the meshing of the rubber pin. ( ) 6. Clean the wiper pivot serration with the wire brush before installation. ( ) 7. We must keep direction of curvature for correct replacement. ( ) 8. The nut of the front wiper arm should be tightened to 30 Nm. ( ) 9. Operate the wiper while running the water or the washer fluid over the window, and check the wiping condition. ( ) 10. The rear wiper can hit against the vehicle body. . The wiper system （刮水系统）lets the driver select from either of two wiper speeds, low or high, or the intermittent wipe delay mode. A knob on the end of the multi-function switch（多功能开关） stalk is rotated to select the desired wiper speed, or the intermittent wipe delay mode and interval. On models equi