10_0_4kV变压器低压侧短路电流的近似计算及应用.pdfVIP

7 3 Vol. 7 No. 3 2009 6 Journal of Fujian Un ivers ity of Technology Jun. 2009 : 672- 4348( 2009) 03- 0268- 03 0/0. 4 kV 林承就 (福建工程学院环境与设备工程系, 福建 福州 350 08) : 通过分析有名值法的计算过程, 推导出一 近似计算 0/0. 4 kV低压侧三相短路电流的计算方 法, 即:在 0/0. 4 kV 配变电所工程设计时, 若高压侧部分相关资料不易获取, 可利用二次侧额定电流 与变压器短路电压即可计算出低压侧的三相短路电流通过实例校验, 结果表明, 该近似算法可以用 来校验相关导体和保护设备的合理选择 : 短路电流; 短路电压; 计算方法 : TM 726. 2 : A Approximate calculation of short-circuitcurrenton the low-voltage side of 10/0. 4kV transformer and its application L in Chengjiu (Environm ental and Equ ipm en t Engineering Departm ent, Fujian University of Technology, Fuzhou 350 08, Ch ina) Abstract: In design ing 0/0. 4 kV d istribution substation, it is essential to acquire theworking para- meters at the high-voltage side of the transformer. An approxmi ate calculation m ethod for three- phase short-circuit current at the low-voltage side of 0 kV transform erw asproposed by analyzing the calculation process ofOhm. s method. The rated current at the secondary side and the short-circuit voltage of the transformer w ere used to calcu late the three-phase short-circuit current. The results show that the approxmi ation calculation method can be used to check the reasonable choice of the as- sociated conductors and protective devices eywords: short-circuit current; short-circu it voltage; calculating method 0 kV , , , 56 ( GB 50054) 95) 2. 2. [ ] 2 4 : 1 , , , k - I ( 3) , [ 2] k , (