51单片机的红外收发C程序_带仿真图.docVIP

发射部分 #include reg52.h sbit P2_2=P2^2; sbit signalBit=P2^1; //发送信号标志位 sbit LED=P3^7; //使能信号位，将E位定义为P2.2引脚 unsigned char irData[]={0x14,0xeb,0xf0,0x0f}; //存放所有的控制码 unsigned char mazhi[]={0x33,0x22,0xeb,0x14}; unsigned char key,send_flag=0; void SendIRdata(unsigned char irdata[4]); //红外发射函数 void anjian_send(unsigned char flag); void delay(unsigned int tt) //延时函数 { while(--tt); } void main(void) { signalBit=0; P2_2= 0; TMOD=0x12;//设定定时器1和0工作方式为1和2 EX1=1; IT1=1; ET0 =1; //定时器0中断允许 ET1 =1; TH0= 0xf4; TL0= 0xf4; //设定时值0为38K 也就是每隔13us中断一次 周期为26us TR0= 0;//先关闭定时器 0 TR1= 0; IP=0X01; EA=1; //允许CPU中断 LED=0; while(1) { P1=0XF0; if(send_flag==1) { anjian_send(key); send_flag=0; } } } void anjian_send(unsigned char flag) { unsigned char zhi=flag; switch(zhi) { case 0xee: SendIRdata(irData); break; case 0xbe: SendIRdata(irData); break; case 0xde: SendIRdata(irData); break; case 0x7e: SendIRdata(irData); break; case 0xed: SendIRdata(irData); break; case 0xdd: SendIRdata(irData); break; case 0xbd: SendIRdata(irData); break; case 0x7d: SendIRdata(irData); break; case 0xeb: SendIRdata(irData); break; case 0xdb: SendIRdata(irData); break; case 0xbb: SendIRdata(mazhi); break; case 0x7b: SendIRdata(mazhi); break; case 0xe7: SendIRdata(mazhi); break; case 0xd7: SendIRdata(mazhi); break; case 0xb7: SendIRdata(mazhi); break; case 0x77: SendIRdata(mazhi); break; } } /******* 定时器1中断处理 ***********/ void isr_T1(void) interrupt 3 { } /******* 定时器0中断处理 38K载波发生器***********/ void timeint(void) interrupt 1 { P2_2=~P2_2; //产生38k的载波信号 } /**************** 中断1 键盘的扫描 ********************/ void Int1(void) interrupt 2 { unsigned char l,h; P1=0XF0; l=P1; l=l0xf0; if(l!=0xf0) { delay(10); if(l!=0xf0) { l=P10xf0