塑壳断路器小安培的解决方案.pdf

塑壳断路器小安培的解决方案 电工电气 (20 0 No.2) 产品与应用 塑壳断路器小安培的解决方案 1 2 2 3 辛超 ，葛广声 ，李朝阳 ，邸鹏 (1 河北工业大学 电器研究所，天津 300130；2 天津电力公司城东供电分公司，天津 300250； 3 唐山供电公司，河北 唐山 063000) 摘 要：为解决小安培的塑壳断路器分断能力问题，介绍了CM1-100型塑壳断路器分断能力的解决 方案。在保证原断路器性能参数和成本的情况下，对断路器热磁脱扣部分进行了改进。可使电流做到更小， 在相同的分断电流情况下，改进后的断路器比现有断路器更易分断，提高了产品的可靠性，降低了生产 成本。 关键词：塑壳断路器；分断能力；小安培；解决方案 中图分类号：TM561 文献标识码：A 文章编号：1007-3175(2010)02-0027-03 Small Ampere Solution Plan for Moulded Case Circuit-Breaker  2 2 3 XIN Chao , GE Guang-sheng , LI Zhao-yang , DI Peng  Electrical Apparatus Research Institute of Hebei University of Technology, Tianjin 30030, China; 2 East Urban Power Supply Branch （ of Tianjin Power Supply Company, Tianjin 30020, China; 3 Tangshan Power Supply Company, Tangshan 063000, China ） Abstract: In order to solve the breaking capacity problem of small ampere moulded case circuit-breakers, introduction was made to a solu- tion plan for the breaking capacity of model CMI- 00 moulded case circuit-breakers. In conditions to assure the performance parameters and cost of the original circuit-breaker, improvement was made to circuit-breaker thermal magnetic tripping part to make current much smaller. Under the same breaking current conditions the improved circuit-breakers were easier to make breaking than existing ones, which raised the reliability of products and cut down the cost of products. Key words: moulded case circuit-breaker; breaking capacity; small ampere; solution plan 0 引言 断路器作为一种开关电器，它除了具有接通和