试题无机材料专业外语B卷.docVIP

第一:（分） 1、Defect: 2、Glass: 3、Ceramic: 4、Surface: 5、Bond: 6、Crystal: 7、Concrete: 8、Cement: 9、Inorganic: 10、Phase: 11、Colloid: 12、Solid: 13、Clinker: 14、Electron: 15、chemistry: 第二、短语翻译:（分） 1、0.1%: 2、摄氏度: 3、an: 4、1/4: 5、1+1=2: 6、米: 7、2×2=4： 8、Silica： Silicon: Silicate: (三选一)： 9、Aluminum： 10、分钟: 第题 ：（20分） Coat a dormant material is an method for controlling the rate of corrosion. 2、Since the electric neutrality must be conserved, the crystal alway simultaneously contains atoms that donates electrons and atoms that accept charged anions. 3、So that their outer shell have either lost excess electrons nor has been filled with a total of eight electrons. 4、Portland cements is made by heat a mixture of limestone and clay to about 1450 °C. Partial fusion occur, and nodules of clinker are produced. 5、In some crystals, the atoms is present in a state where they electron system is similar to that of a rare gas. 第题：（分） discussed in the last section, this is a relatively open structure. (b) Quartz has a structure, which can be viewed as composed of connected chains of silica tetrahedral. (c) Crystalline silica exists in several different polymorphic forms---quartz、tridymite and cristobalite. (d) However, quartz has a greater density and closer packing than either of the high-temperature forms, tridymite (2.26) and cristobalite (2.32). (e) For example, the density of quartz is 2.65 g/cm3, compared with 3.59 for MgO and 3.96 for Al2O3. 请你就认为正确的顺序排序： 、 、 、 、 。 第：（分） The viscosity（粘度） before injection is an important parameter controlling even（均匀的） filling of the mold and avoiding air bubbles（气泡） finished components （成品部件）. Large amounts of polymer are used, 30 volume %, although solid content in the mixture can be maximized optimization o