ASME标准讲解4(ASME具体材料).pptVIP

四、ASME具体材料 ASME材料所用的标准 核电建设所用的ASME标准内容 (1) Section III, Nuclear Power Plant components, Division 1 ?Subsection NB Class 1 Components (2) Section II, Material Specifications ?Part A - Ferrous Materials ?Part B - Nonferrous Materials ?Part C - Welding Rods, Electrodes and Filler Metals ?Part D - Properties (3) Section V, Nondestructive Examination (4) Section IX, Welding and Brazing Qualifications (5) Section XI, Rules for In-service Inspection of Nuclear Power Plant Components, Division 1 承压设备材料 Pressure retaining material and material welded thereto, except as permitted in NB-4435, and except for welding material, shall conform to the requirements of one of the specifications for material given in Tables 2A and 2B of ASME Code Section II, Part D, Subpart I and to all of the special requirements of Article NB-2000 which apply to the product form in which the material is used, except as they may be modified by the requirements of this Specification. 其它材料 Non-structural attachments, such as insulation supports, name-plates, and temporary attachments, if required, may be noncertified material. Non-pressure retaining material, such as cooling shroud support, alignment pin, stud bolt elongation measuring rods and tools, if any, may be of ASME or other Standards . The following requirements shall be applied, unless otherwise specially or additionally specified in this Specification. a. NB-2210 Heat treatment requirements b. NB-2220 Procedure for obtaining test coupons and specimens for quenched and tempered material. Fracture toughness requirements for material The following requirements shall be applied, unless otherwise specially or additionally specified in this Specification. a. NB-2310 Material to be impact tested b. NB-2320 Impact test procedures c. NB-2330 Test requirements and acceptance standards d. NB-2340 Number of impact tests required e. NB-2350 Retests f. NB-2360 Calibration of instruments and equipment Acceptable M