基于MSCMarc的摩擦叠焊面接触问题数值模拟.pdfVIP

2 1 4 Vol . 2 1 No . 4 2008 12 JOURNAL OF PETROCHEMICAL UNIVERSIT IES Dec. 2008 : 1006- 96X(2008) 04- 0068- 05 M SC. M arc 陈家庆, 焦向东, 邱宗义, 张宝生, 陈忠海 ( , 102617) : 选用刚性平冲头与弹性半空间的经典面接触模型为研究对象, 通过解析解与M SC. Marc 有限 数值 模拟结果的比较,确定了偏斜网格以及 级有限 计算对已知接触区域面接触问题的可靠性对于摩擦叠焊单 成 形过程所涉及的基本弹性静力学面接触问题而言, 接触面上的法向应力分布从中心向边缘以二次曲线的形式逐渐 增大; 金属棒直径轴向外载荷对接触面上法向应力的分布情况影响较大, 而径向间隙不同材料组合对其的影响相 对较小 : 面接触; 有限 ; 摩擦液柱成形; 弹性静力学 : T G404; TB115 : A Numerical Simulation on the Surface- Contact Problem of Frict ion- Stitch- Welding Based on MSC. Marc CHEN Jia- qing, JIAO Xiang- dong, QIU Zong- yi, ZHANG Bao- sheng, CHEN Zhong- hai ( Research Centre of Of f shore Eng ineering Joining Technology , Beij ing Institute of Petrochemical Technology, Beij ing 102617, P. R. China) Receiv e 10 A p ril 2008; rev ise 2 October 2008; accep te 12 N ovember 2008 Abstract: Taking the surface- contact model between rigid flat punch and elastic half - space as the research subject, and through com paring the results of analytical solution and numerical simulation by t he finite element method ( FEM) software MSC. Marc, it is determined that the non- uniform meshing method and the third grade FEM calculation are reliable as to the surface- contact problem w it h definite contact area. For t he most fundamental surface- contact problem involved w ith friction hydro pillar processing in friction stitch w elding, the normal stress on the contact surface increases quadratically from center to the marginal side. The diameter of the metal stud and the applied external load has more influence to the d